Operating instructions: Type V / VS / S
Contents
1. REGAL a ee Operating instructions Type V VS S This operating manual is intended to help you to commission the ATEK drive in accordance with relevant regulations The stated features of our transmissions and the fulfilment of potential guarantee claims depend on compliance with these directions Before the drive was shipped it was subject to strict tests and was properly packed Before starting operation check for transport damage Report any damage to the transport company immediately If the transmission is not to be installed immediately we request that you store it appropriately to its design in a dry place without mayor temperature changes Lubrication Please refer to the information given on the identification plate on the transmission Transmissions with lifetime lubrication have been factory fitted with the necessary amounts of lubricants Subsequent lubrication is only necessary when a substantial amount of lubricant has escaped due to leakage The type and viscosity of lubricant to be added must be obtained from the manufacturer whilst stating the serial number of the transmission Transmissions for oil change lubrication are delivered without lubricant and must be filled before commissioning with an oil or grease in accordance with our lubricant recommendation Assembly The transmissions should always be installed according to the fitting position that has been ordered The gear unit should be set up on appropriate solid2. foundations or mounted as a flange drive directly on the machine to be driven The shaft ends have to be aligned very carefully for quiet running and safety during operation To compensate for minor mounting inaccuracies we recommend the use of elastic couplings The couplings must be warm or must be mounted with the aid of D centring and a screw Do not hammer This will avoid damage to the tooth profile rolling bearings and locking rings Plug in transmissions can be fitted directly onto the shaft of the driven machine For flange gears it is important that the attachment surface is it exact right angles to the machine shaft s axis Otherwise the bearings will suffer too much stress and might be damaged The reaction torque corresponding to the output torque can be supported with a torque converter bearing The bar should be mounted on the gears machine side in order to prevent additional bending stresses Do not mount the gears directly on a foundation plate when the machine shaft is bedded near the gears For hollow shafts with a shrunk on flange please additionally refer to our assembly instructions for shaft hub connections Commissioning Where ventilation of the transmission is desired the vent hole is sealed for transport To prevent excess pressure in the transmission an hence leakage the locking screw must be removed and replaced by the provided venting filter before setting the gear in motion If the temperature of the gear box housing
3. does not exceed 50 C during operation the vent filter must not be fitted Maintenance All ATEK drives require only a minimum of maintenance For drives with lifetime lubrication this is reduced to regular checks of the transmission for lubricant loss through leakage For transmissions with oil change lubrication please refer to our lubricant recommendation Regal A S Industrivej 4 4000 Roskilde Tif 4677 7000 Fax 4675 7620 regal regal dk www regal dk
Download Pdf Manuals
Related Search