Agio Sling Chair Assembly Instruction
Contents
1. QTY PCS SEAT FRAME 2 N SEAT BASE 3 Qmm 14 x35MM BOLT 4 Omm 1 4 x45MM BOLT 2 5 WASHER 2 6 HEX BOLT DRIVER 1 7 HEX WRENCH 1 MODEL 50 46490 4872. IMPORTANT PLEASE READ ENTIRE INSTRUCTION SHEET BEFORE ASSEMBLY IMPORTANT NOTE Your sling seat may appear to be slightly warped This is not unusual Proper assembly procedure will straighten out the sling seat in the frame There are four bolts used to attach the seat frame to the seat base After inserting all the bolts each of these bolts must be tightened a few revolutions at time in rotation Step 1 Identify all parts packed in the carton against the parts list Remove all protective materials Set parts on a flat non abrasive surface to avoid scratching If you are missing any parts or are unsure how to proceed with assembly call our Customer Service Center immediately at 1 800 416 3511 Do not attempt to assemble chair if any parts are missing or damaged IMPORTANT NOTE Assembling this chair requires attaching the sling seat frame to the seat base We recommend two people work together to assemble the chair since it is critical that all the holes in the seat frame are aligned exactly with the holes in the seat base All bolts need to be inserted and tightened into the fixed nuts in a straight and direct path Inserting the bolts at even the slightest angle could strip the nuts and bolts damaging the entire chair Step 2 Working from behind the chair have another person stand in front of the chair and position the sling seat frame in between the arms of the seat base as shown so that the holes on both sides of the upper portion
3. of the seat frame back align with the fixed nut holes in the seat base Step 3 From behind the chair insert a bolt 1 4 x35mm through the hole on one side of upper portion of the seat frame and into the fixed nut in the back arm portion of the seat base Make sure the bolt is inserted exactly straight Hand tighten 3 4 revolution only DO NOT TIGHTEN COMPLETELY Repeat for opposite side of chair Step 4 Working from the front of the chair add a washer to a bolt 1 4 x45mm From the underside of the front seat support bar insert bolt with washer through one of the holes in the seat support bar into the fixed nut inside the lower front portion of the seat frame Hand tighten 3 4 revolutions only DO NOT TIGHTEN COMPLETELY Repeat for opposite side Step 5 Tighten all bolts Each bolt must be tightened a 3 4 revolutions only at a time Begin with top left bolt Move to bottom right bolt then to top right bolt followed by bottom left bolt Repeat this X pattern until all bolts are tight DO NOT OVER TIGHTEN BOLTS Over tightening may strip bolts or nuts damaging the entire chair Step 6 Examine the chair from the front If the sling seat does not appear tight or straight in the seat base repeat steps 3 4 and 5 If you do not feel your chair is assembled properly or you have any questions call our Customer Service Center at 1 800 416 3511 Page 2 lt A d a j FRONT SEAT SUPPORT BAR DESCRIPTION
Download Pdf Manuals
Related Search