Agio Rectangular Inlaid Glass Table Assembly Instruction
Contents
1. service department 800 416 3511 Page 2 IMPORTANT PLEASE READ ENTIRE INSTRUCTION SHEET BEFORE ASSEMBLY PANETT DESCRIPTION QTY PCS Step 1 CAREFULLY remove glass and set aside until Step4 Attach a leg to the leg connector bracket by carefully 1 o GLASS TOP 1 Step 7 Lay glass flat do not stand on edge guiding the bolts already in place on the table legs each Set parts on a flat non abrasive surface Remove leg has two bolts through the holes in the leg connector all protective materials Identify all parts packed bracket Add a washer and a nut to the end of each bolt in carton against the parts list If you are missing Hand tighten only Repeat on other three legs 2 TABLE RIM 1 any parts or are unsure how to proceed with assembly call our Customer Service Center at Step5 Using a 1 4 x25mm bolt attach a topside support 1 800 416 351 1 Do not attempt to assemble the to the leg connector bracket Add a washer to each bolt 3 i LEG CONNECTOR 1 table if any parts are missing or damaged and guide this through the inside of the leg connector amp J BRACKET bracket and into the fixed nut already in place in the Step2 Place the table rim without glass upside down topside support Hand tighten only Repeat for other side on a flat non abrasive surface to avoid scratching 4 TABLE LEG 4 the2. 8 evenly throughout the inside of the table rim CAREFULLY place the glass inside the rim resting on the clear bumpers Your table is ready for use If you have any questions please call our customer 13 PVC NUT COVER 8 MODEL 553860 22 487
3. rim Attach a leg to the rim using a 1 4 x20mm bolt Add a washer to bolt then guide this into the pre drilled hole already in place in the table rim 5 SD TOPSIDE SUPPORT 2 Hand tighten bolts Repeat on the other three legs Important note Hand tighten bolts only for this step Do not over tighten Some adjustments may be necessary to ensure table legs are aligned properly 6 Quum 1 4 x20MM BOLT 6 Step3 Attach a topside support to the rim using the 1 4 x20mm bolt Add a washer to each bolt then Quum oF guide into the pre drilled hole in the table rim Hand 7 1 4 x25MM BOLT 2 tighten bolts Repeat on the other side Important note Hand tighten bolts only for this step Do not over tighten Some adjustments may be necessary to 8 NUT 8 ensure table legs are aligned properly Step6 At this time make any minor adjustments in the alignment 9 WASHER 16 of the table legs or topside supports Once you have a legs and topside supports in the correct position use the Hex Bolt Drive and Hex Wrench provided to tighten all nuts and bolts Note Each bolt must be tightened a few 10 HEX WRENCH 1 revolutions at a time In order to apply even pressure we recommend you alternate between nuts and bolts working in a cross corner X fashion DO NOT OVER 11 HEX BOLT DRIVER 1 TIGHTEN Cover all nuts and bolts with PVC covers Step7 With the help of another person turn the table in the upright position Note the clear bumpers spaced 12 B PVC BOLT COVER
Download Pdf Manuals
Related Search