Admiral Craft HDS-1200W Owner's Manual
Contents
1. Slide in glass windows for both the back and front of the unit Pour six quarts of water into the base of the unit to cover the heating element DO NOT OVERFILL It is recommended that you use hot water to reduce preheat time Make sure valve drain cap 1s screwed tightly closed Once the water 1s in place the perforated rectangular base on the left side of the unit Place the square base plate with the control lever on the right side of the unit Slide the partition piece into the left slots to separate the hot dog and bun sections of the steamer Place the hot dog rack to the of the left side compartment Make sure the rack is standing on its feet to allow proper circulation of steam Place the bun rack on the right side in the bun compartment Place lid beam in the middle of the unit so the lids rest on the edges of the beam Place lids down on unit edges and swing closed Adjust lid beam to fit if needed Ensure that the unit is plugged into a grounded and properly sized electrical outlet to minimize shock or fire hazard Refer to the electrical requirements on the serial tag located on the operator side of the unit Turn the switch on and set the thermostat control on the highest setting until steam is generated For normal operation set the thermostat control in the center of the range between the highest and lowest temperature 130 degrees Place hot dogs in the small compartment and buns on the wire rack in the large c2. HDS 1200W Hot Dog Steamer This manual contains important information regarding your Admiral Craft unit Please read this manual thoroughly prior to equipment set up operation and maintenance Failure to comply with regular maintenance guidelines outlined in this manual may void the warranty MUST READ WARNINGS Do not touch any hot surfaces Do not immerse unit cord or plug in liquid at any time Unplug cord from outlet when not in use and before cleaning Plug only into a 3 hole grounded electrical outlet Do not operate unattended Do not use this unit for anything other than intended use Do not use outdoors Always use on a firm dry and level surface at least 12 from walls or any other obstruction Do not use if unit has a damaged cord or plug in the event the appliance malfunctions or has been damaged in any manner Keep children and an mals away from unit Any incorrect installation alterations adjustments and or improper maintenance can lead to property loss and injury All repairs should be done by authorized professionals only Ensure that the designated power supply is adequate for continual usage and the voltage is correct TO INSTALL ee a N E en 16 17 18 19 Remove unit from the box and remove all parts With the operator side facing you dial to the left set 1t down on a flat sturdy surface Open the top flaps of the unit and remove the parts and packing foam Put the parts to the side
3. d replaced with a refurbished unit or replaced with a new unit by ACE after defective unit has been inspected and defect has been confirmed ACE does not assume any liability for extended delays in replacing any item beyond its control This warranty does not apply to rubber and non metallic synthetic parts that may need to be replaced due to normal usage wear or lack of preventative maintenance This warranty covers products shipped into the 48 contiguous United States Hawaii and metropolitan areas of Alaska and Canada Warranty coverage on products used outside the 48 contiguous United States Hawaii and metropolitan areas of Alaska and Canada may vary Contact ACE for details at 1 800 223 7750 The following conditions are not covered by warranty e Equipment failure relating to improper installation improper utility connection or supply and problems due to improper ventilation e Equipment that has not properly been maintained damage from improper cleaning and water damage to controls e Equipment that has not been used in an appropriate manner or has been subject to misuse neglect abuse accident alteration negligence damage during transit delivery or installation fire flood riot or act of God e Equipment that has the model number or serial number removed or altered e Equipment on which the security seal has been broken If the equipment has been changed altered modified or repaired without express written permission fr
4. om ACE then the manufacturer shall not be liable for any damages to any person or to any property which may result from the use of this equipment thereafter This equipment is intended for commercial use only and this warranty is void if equipment is used in other than a commercial application For warranty and non warranty related issues technical support purchase replacement parts and warranty registration visit www admiralcraft com Please have your model number serial number and proof of purchase ready It is not necessary to contact the place where you originally purchased your product from THE FOREGOING WARRANTY IS IN LIEU OF ANY AND ALL WARRANTIES EXPRESSED OR IMPLIED INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILTY OR FITNESS FOR PARTICULAR PURPOSES AND CONSTITUES THE ENTIRE LIABILITY OF ACE IN NO EVENT DOES THE LIMITED WARRANTY EXTEND BEYOND THE TERMS STATED HEREIN VER1212
5. ompartment Arrange the hot dogs and buns so that there is enough room for circulation of steam To control the amount of steam in the bun compartment use the adjustable humidity control lever located in the bun compartment under the wire rack Keep lids closed when not serving Add hot water when necessary to maintain the water level Do not allow the unit to burn dry If you accidentally run it dry turn off and allow the unit to completely cool before adding water Adding water to a dry unit while it is still hot could cause damage to the elements CLEANING NOTE To maintain cleanliness and increase service life the hot dog steamer should be cleaned daily Do not immerse the unit in water or any other liquid If liquid enters the electrical compartment it may cause a short circuit or electrical shock SS Disconnect the power cord from the electrical outlet Allow the unit to cool down completely Remove any remaining hot dogs and buns Drain the water using the drain pipe located on the operator side Detach all removable parts including the bun rack perforated trays steam control lever partition and glass panels Thoroughly clean the unit Although stainless steel is corrosion resistant for longevity purposes the unit should be cleaned after every use TROUBLESHOOTING Troubles listed are for reference If any fault occurs please discontinue use Do not attempt to repair yourself This will void the warranty Problem Ca
6. use Cool air striking the warm Condensation on glass partition surface of the steamer Too much steam is being Hot dog casing burst generated Too much steam is being Buns too soggy generated Too much steam is being Buns too dry generated Solution Avoid placing the unit against cool drafts of air Reduce the thermostat control to a lower setting Adjust the steam control level Adjust the steam control level Hot Dog Steamer HDS 1000W HDS 1200W Circuit diagram 1 OkW 120V 50 60Hz Thermostat Heating Ny element Temperature limiter HUE Heating element Temperature limiter Power cord HE ZRAWG16 X 3 fe Wb 2 EH WFE 38 Thermostat HDS 1000W HDS 1200W VER811 Hot Dog Steamer HDS 1200W Reference Description me with Bottom Plate VER811 ACE Equipment One Year Limited Warranty Admiral Craft Equipment Corp ACE warrants its equipment against defects in materials and workmanship subject to the following conditions ACE Equipment is warranted for one year effective from the date of purchase by the original owner A copy of the original receipt or other proof of purchase is required to obtain warranty coverage This warranty applies to the original owner only and is not assignable Should any product fail to function in its intended manner under normal use within the limits defined in this warranty at ACE s discretion such product will be repaire
Download Pdf Manuals
Related Search