Warning Installation Information ProDim 250
Contents
1. Behind the touch plate disc are two fixture holes and a touch plate contact pin Touch Plate Light switch ON OFF OFF Position a g i l _ Do NOT remove this cover g ig T ProDim 250 Do NOT remove p Turn to open the insulating tape This will be visible on the product C Turn to close Important information The lights will come ON to full brightness after a power cut Switch OFF ProDim 250 via the light switch when going away for a long period of time CLAD Telephone 01753 692916 www cadelectronics co uk ProDim 250 is design and manufactured in England to E standards CAD Electronics Copyright 2012 2013 Ver1 12. Warning ProDim 250 is mains operated 230V AC 50Hz INDOOR USE ONLY Do NOT exceed 250 Watts Sum of all bulbs connected Do NOT use with fluorescent or energy saving lighting Do NOT use with NON dimmable transformer ProDim 250 User Guide Thank you for purchasing ProDim 250 We hope you have many years of trouble free use Warrant is 3 years from date of purchase Keep receipt in a safe place Only to be installed by an competent person _ Before installation begins SWITCH OFF power at the consumer unit Fuse box Undo wall light switch screw Remove the wires from the wall light switch Wire in ProDim 250 See opposite Do not over tighten the two screws which hold ProDim 250 to the wall fixture Check the light switch on ProDim 250 is in the OFF position Switch ON power at consumer unit Switch ON ProDim 250 light switch the lights will come on to maximum brightness ProDim 250 will emit a faint buzzing sound and get a little warm this is normal when the lights are ON ProDim 250 can be used with Filament Bulb and 12V Halogen dimmable electronic transformer ONLY or B W PD o N OD User Instructions ProDim 250 light switch ON 1 To switch OFF the lights momentarily touch the touch plate 2 To switch ON the lights to maximum brightness Touch the touch plate the lights will come ON there will be a small pause Recall see below after this small pause remove your finger Touch acro
3. ss the two half circles to switch lights ON to maximum brightness or switch lights OFF The remote control is the only method of increasing and decreasing the light level Remote control bottom pair of touch plates decrease light level the top pair of touch plates increase light level By continuously touching the top or bottom pair of touch plates a continuous light level STEPPING ACTION is achieved Remove finger from the touch plates to stop at a light level ProDim 250 remembers your last light level prior to lights OFF via remote control or ProDim 250 touch plate To recall this light level 1 Momentarily touch the ProDim 250 touch plate 2 Remote control momentarily touch the top or bottom pair of touch plates Switch ProDim 250 light switch OFF when a light bulb needs replacing Installation Information On the back of the ProDim 250 there is an information label giving details of how to connect ProDim 250 to your light switch wiring Information label not shown in picture below LIVE IN gt this is the connection for the LIVE wire SWITCHED LIVE gt this is the connection to your light s Remove the small sliding cover above the terminal block to get access to the terminal block screws When removing the touch plate disc take care not to damage the touch plate contact pin protruding from the main body of ProDim 250 Now visible are two fitting screw holes Use the screw supplied to install ProDim 250
Download Pdf Manuals
Related Search