SUNSHADE BLINDS USER GUIDE
Contents
1. SUNSHADE BLINDS USER GUIDE General All units are fully tested before leaving the Sunshade Factory should have been tested by your installer on receipt and should have been tested for correct operation by your installer after the units had been installed Should you have any issues with the appearance or operation of the blinds the you should refer to your installer for advice and help Failure to maintain the blinds may cause internal damage and invalidate the warranty Blind Operation The blinds utilise a very stable and reliable system which require low levels of maintenance to ensure full and long lasting operation Operated by control magnets sliding on rollers on the surface of the glass the blinds can be fully raised and lowered and tilted and turned The magnets sit over tracks at the sides or bottom for tilt turn only blinds of the sealed unit The blinds can be raised lowered and tilted turned by sliding the control magnets up or down their tracks The magnets may be held in the correct position over the track by guide rails if fitted which ensure the magnets cannot come loose from the window or door There will be no difference in operation of the blinds whether fitted with or without the guide rails For best operation the slats should be in the horizontal position before the blind is raised When the slats are being raised or lowered it is advisable to look at the slats whilst operating the blind in this way pressur2. e can be reduced as approaching the fully raised or fully lowered position This will avoid the magnet slipping out of alignment with the magnets inside the track Cleaning To ensure that the control magnets remain easy to operate it is necessary to clean the glass tracks and back of the magnets if not fitted with guide rails at regular intervals The glass tracks should be cleaned a minimum of every three months to maintain satisfactory operation The backs of magnets and the rollers on their carriages may be cleaned providing no guide rails are fitted Cleaning should be done with a damp cloth only No solvents or cleaning fluids should be used Replacing and Relocating the Magnets lf guide rails are not fitted it will be possible to remove the magnets by sliding them sideways on the surface of the glass off the tracks To replace or relocate a magnet in the correct location it should be positioned on the surface of the glass at the top of the track The magnet should then be slid slowly down the track until a light pressure is felt as it begins to engage with the magnet inside the track The magnet should be slid further down the track until a greater pressure is felt Push the magnets still further downwards until a loud click is heard at this point the magnet is fully engaged The blind can then be operated normally This will apply to both the raise lower and the tilt turn functions Please contact your installer if you need any fu
3. rther advice
Download Pdf Manuals
Related Search