NETWORK OPERATING INSTRUCTIONS 12pCO DOMINO System
Contents
1. Istruzioni per la messa in rete DOMINO operation for DOMINO network THE AIRVOLUTION j Thermocold THE AIRVOLUTION NETWORK OPERATING INSTRUCTIONS 12pCO DOMINO System Hydronic modular groups with scroll compressors GUDOM DOEL REVOO 0613 UK Thermocold Istruzioni per la messa in rete DOMINO operation for DOMINO network THE AIRWVOLUTION 1 Netwok Configuration The software provides customizing the network configuration based on the number of units chiller heat pump and only chiller units The software provides for the assignment of addresses to PCOS cards on the network The addresses to be assigned to the PCO units in the network are the progressive values ranging from 1 for the Master unit up to 12 In particular in the case of a network of machines composed by machines chiller and heat pump the only Chiller units will receive the last P Lan network addresses for example a configuration with 7 units of which 4 heat pumps and 3 only chiller the 4 heat pumps must have address respectively 1 2 3 and 4 while only chiller units respectively 5 6 and 7 This is because during winter the operation mode will be only heat pumps and the master must necessarily be one of them 2 Address Configuration Operating Instructions We show below an example of an address configuration using the accessory kit DOMINO GENIUS e disconnect the network connector for each machine e connect the terminal to the pCO e give power2. system At this point the main menu mask will appear To view SLAVEs press the INFO button and in the mask that appears press ENTER and enter the address of the unit to control and press ENTER again to confirm To return from a SLAVE to MASTER you must log into the INFO mask and set address 1 4 At the end of the addressing operation you can then proceed to complete the configuration steps of the network In the C4 mask in the manufacturer branch of the MASTER card you can enter the number of units only chiller and the number of heat pump units of the network and in the C1 mask you can enable the B2 probe outlet water temperature system For modular units ordered with MASTER amp SLAVE configuration the customer must only perform the procedure in step 3 GUDOM DOEL_REV00_0613_UK
3. to the board press the ENTER key and the two directional buttons for more than 5 seconds the following screen will appear Display address setting I O Board e change the address on the keypad press ENTER change the value to 0 and press ENTER again to confirm e power off the Pco card Power up again Pco and simultaneously press the ALARM key and the Up arrow until the appearance of the mask pLan address UP increase DOWN decrease ENTER save amp exit e Set 1 for the Master address by pressing UP and DOWN buttons and then press ENTER to confirm GUDOM DOEL_REV00_0613_UK i Thermocold Istruzioni per la messa in rete DOMINO operation for DOMINO network THE AIRWVOLUTION e Remove power to the board Pco e Disconnect the GENIUS terminal and connect it to the other units and repeat step 2 by assigning the addresses according to the rules written above e After these operations reconnect the GENIUS terminal to the M aster unit 3 e Give power to the Pco board by simultaneously pressing the ENTER and the arrow keys for 5 seconds this screen will reappear Terminal config Press ENTER to continue e tochangethe keypad address press ENTER the following screen will appear P 01 Adr Priv Shared Trml 32 sh Trm2 02 Trmi e set address 16 and in the adjacent field you must set SH share and press ENTER to confirm After configuring all units restore the network connections and power up the
Download Pdf Manuals
Related Search