Lithium-Polymer (Lipol I Lithium-Ferrite (LiFe - Component-Shop
Contents
1. 1 hour 46 mins or for LiF 7000 1 1 76 or for LiFe battery 7500 x 1 1 1 17 hours 1 hour 10 mins L 03r1 00 Component Shop co uk Ltd 20142. Lithium Polymer Lipo Lithium Ferrite LiFe Smart Charger operating instructions Safety First 1 This charger must only be used amp stored in a dry environment away from sources of moisture heat amp direct sunlight 2 This charger is suitable for charging only lithium polymer Lipo battery packs with nominal voltages of 7 4V or 11 1V 2S or 3S or lithium ferrite LiFe battery packs with nominal voltages of 6 6V or 9 9V Charging any other battery types or other battery voltages should not be attempted Batteries should only be charged in an open uncluttered space away from any combustible materials 4 Should the charger s casing or any of the leads become damaged it should not be used In such cases it should be referred to a suitably qualified technician for repair in order to avoid a hazard 5 Lithium polymer amp Lithium Ferrite batteries should only be charged within the temperature range 0 C 50 C Operation 1 Operation of this charger is simplicity itself Simply plug the 12V dc power supply into the mains amp connect to the charger the red power LED will illuminate 2 On the side of the charger next to the power supply input socket is a small switch to select the battery type Move the switch to the left for Li Fe amp to the right for Li Po y C RoHS AB Battery type select 2 lt MODE gt 1 switch DC power socket 3 Connect the battery balance plug to the charger The charger wil
3. l accept JST XH type plugs 3 pin for 2S 6 6V LiFe 7 4V Lipo batteries amp 4 pin for 3S 9 9V LiFe 11 1V Lipo batteries Batteries with other types of balance plugs will require a suitable adapter Do NOT try to force a different connector into the charger output socket 4 Once connected the green charging LED will flash rapidly approximately 2 3 times per second Note If the red LED also flashes this indicates that the voltage of one or more of the cells within the battery pack is too low for the charger to safely charge amp so this battery cannot be charged with this charger This is an important safety feature as charging a lithium polymer battery when the voltage has dropped too low can in extreme cases cause it to ignite 5 The green LED will stop flashing amp stay on once the battery is fully charged at this point the charger will stop the charging process so that the battery will not become overcharged 6 Disconnect the battery Charge Times There are many factors which can effect the length of time a battery will take to charge so the following formula should be taken as a rough guideline only Charge current for Lithium Polymer batteries is 1 000mA 1 Amp and for Lithium Ferrite batteries is 1 500mA 1 5 Amps Battery Capacity Charger Output x 1 1 Charge Time in Hours For example a 1600mAh lipo battery being charged with this charger at 1000mA would work out as follows 1600 1600 X 1 15 1 76
Download Pdf Manuals
Related Search