Photocell beam sensor User Manual (P5101)
Contents
1. Photocell beam sensor User Manual P5101 a Q al ed z A 4 Bi e de dn ei 7 Ta I Technical Specification 1 Working voltage 12 24VAC DC or 3V Dry Battery Working current 24VDC emitter lt 8mA receiver lt 40mA Photocell wavelength 940nm Angle of opposite emission lt 52 Receiver range 212m Internal Rotation system adjusted Angle 0 180 2 Working temperature 202 60 U Relay contact loading capacity 1A 30VDC Se he te A ES Waterproof grade IP54 10 Size 128 50 28mm II Safety Instruction For security please read the user manual carefully before initial operation This photocell is without any fuse so Please make sure the power is off before installation Only used this system that do not cause any danger life or property during the running failure or its security risks eliminated Please guarantee the products used in effective working range lll Picture Display Emitter Receiver D PHOTO LOW BAT IV Installation instruction 4 1 You can choose external power supply 12 24V AC DC or Battery supply by Latch or Jumper J2 in picture 3 4 1 1 put the short circuit cap on Ext Power Supply voltage 12 24V AC DC 4 1 2put the short circuit cap on BATTERY Battery voltage 3VDC 4 2 You can set the switch of photocell NO and NC by jumper J5 in picture 4 4 2 1 when the short circuit cap on NO The photocell will be Normal Open 4 2 2when the short circuit cap on NC the photocell will be normal clos2. ed 4 3 Installation 4 3 1 4 3 2 4 3 3 4 3 4 The photocells should be installed more than 20cm above the ground to avoid reflection and the distance between emitter and receiver shall be more than 50cm End user should install the photocell on the back of the direct sunlight or other strong light source 52 to keep photocell work well steadily Avoid installing other infrared photocell emitters within the effective distance of receiver If the end user need to install other photocells in one same straight line the receivers could be installed in the two ends and the emitters could be back to back installed Stable installation could avoid the signal of emitter and receiver skewing due to lightly vibrate and the malfunction 4 4 Wire connection 4 4 1 4 4 2 4 4 3 You can choose safety edge or not according to your requirement PLS see PIC5 amp PIC 6 PHOTO is the switch contact and changed by NO or NC PLS see 4 2 LOW BAT is the low voltage alarm switch to buzzer when working voltage of emitter module is lower than 2V Also it can activate the external alarm You will find LED will turn on when you make alignment at the emitter and receiver or led will off When J5 is keep NC alignment the emitter and receiver LED will be on photocell switch will work if someone or something shelter the sensor the Led will turn off photocell switch will be does not work V Installation Pictures Opening package and
3. taking out accessories 5 Fixing bottom 2 Fixing the holder location map on wall 6 Put upper cover on 3 Drilling and fixing expansion pipe 7 Screw bottom and upper cover together 4 lines 8 Connecting Finished mee e S
Download Pdf Manuals
Related Search