INSTALLATION MANUAL for ZSC-500 SITE
Contents
1. 4 Rx Tx 5 Gnd 5 Gnd Frame earth 8 5V Frame earth RS422 1 Rx 2 RxX RS422 485 RS422 485 3 Gnd 4 Rx Tx 1 Rx Tx 4 Tx 2 Rx Tx 2 Rx Tx 5 TX 3 Gnd 3 Gnd 6 earth 4 Tx NC 4 Tx NC 5 Tx NC 5 Tx NC 6 earth 6 earth Frame earth Frame earth v 7 4 ZSC 500 connection diagram INTERSITE INTERSITE IN OUT ZoneVu Q INICATES PIN 1 9 way D type 9 way D type 9 way D type QYwayD type 6 way female female male female 2 part MEYERTECH LIMITED OFFICE BLOCK ONE SOUTHLINK BUSINESS PARK OLDHAM OL4 1DE TEL 0161 628 8406 Whilst every effort has been made to confirm the information in this document is correct MEYERTECH LIN or any errors omissions and or incorrect information contained within this document No part of this document may be reproduced or distributed in any form or by any means withc YERTECH LIMITED MEYERTECH LIMITED is committed to continuous product development and therefore reserves the right to change specifications without notice 2000 14 ALL RIGHTS RESERVED ZSC 500 Installation Manual Issue 02 Page 7 of 10 Support Tel 44 0 161 6437956 email tech support meyertech co uk www meyertech co uk Intersite Requirements Supported Sites The site controller can connect to a large number of remote sites Remote Site ZSC 500 Peer peer Direct connection 16 Simplex Direct connection 99 Dialup co2. merchantability or fitness or otherwise Items manufactured by any supplier other than Meyertech shall bear only the warranty made by the manufacturer of that product and Meyertech assumes no responsibility for the performance or reliability of that product Meyertech will not be liable for any special or consequential damages or for loss damages or expense directly or indirectly arising from the use of the products or any inability to use them either separately or in combination with any other equipment or material or from any other cause This warranty does not extend to any product manufactured by Meyertech which has been subject to misuse neglect accident war civil disturbance terrorist acts improper installation act of God or in violation of the instructions supplied by Meyertech Whilst every effort has been made to confirm the information in this document is correct MEYERTECH LIMITED cannot accept any liability for any errors omissions and or incorrect information contained within this document No part of this document may be reproduced or distributed in any form or by any means without prior written consent from MEYERTECH LIMITED MEYERTECH LIMITED is committed to continuous product development and therefore reserves the right to change specifications without notice 2000 14 ALL RIGHTS RESERVED ZSC 500 Installation Manual Issue 02 Page 10 of 10 Support Tel 44 0 161 6437956 email tech support meyertech co uk www meye
3. 256 Local Keyboards GUIs 16 Local Peripherals 40 Local Alarm Events 500 Local Sequences 8 Intersite Video Export Intersite Camera Control Export Intersite Capabality Full peer to peer Intersite Output trunks 39 Timed events 100 Information regarding other Meyertech products and technical information can be found at our website http www meyertech co uk Whilst every effort has been made to confirm the information in this document is correct MEYERTECH LIMITED cannot accept any liability for any errors omissions and or incorrect information contained within this document No part of this document may be reproduced or distributed in any form or by any means without prior written consent from MEYERTECH LIMITED MEYERTECH LIMITED is committed to continuous product development and therefore reserves the right to change specifications without notice 2000 14 ALL RIGHTS RESERVED ZSC 500 Installation Manual Issue 02 Page 4 of 10 Support Tel 44 0 161 6437956 email tech support meyertech co uk www meyertech co uk CONNECTING THE ZSC 500 To obtain the optimum performance from your ZSC 500 Site Controller please take time to read this manual before commencing installation If you have any questions or problems our staff will be pleased to assist you on our support line TEL 44 0 1724 278833 Unpacking Unpack the ZSC 500 and check the contents against the list below ZSC 500 1u 19 inch Euro enclosure Power Supp
4. YERTECH LIMITED cannot accept any liability for any errors omissions and or incorrect information contained within this document No part of this document may be reproduced or distributed in any form or by any means without prior written consent from MEYERTECH LIMITED MEYERTECH LIMITED is committed to continuous product development and therefore reserves the right to change specifications without notice 2000 14 ALL RIGHTS RESERVED ZSC 500 Installation Manual Issue 02 Page 3 of 10 Support Tel 44 0 161 6437956 email tech support meyertech co uk ZSC 500 INTRODUCTION www meyertech co uk Thank you for purchasing the ZoneVu ZSC 500 System Site Controller ZoneVu ZSC XXXX As the name suggests the ZoneVu System Site Controller product family are responsible for co ordinating communications at each site Currently three variants are available each having a different level of specification the ZSC 500 ZSC 1000 and ZSC 1000plus models which offer third party control interfaces remote site access and local site control full peer to peer intersite access comprehensive system backup and audit facilities and on line remote support when connected to a PC GUI SYSTEM PARAMETER ZSC 500 SUPPORT Local ZoneVu Ports 2 ZoneVu PC2 Remote ZoneVu Ports 2 ZVR1 ZVR2 Local 3 Party Control Ports 1 PC1 Remote 3 Party Control Ports 2 ZVR1 ZVR2 Intersite ZoneVu Ports 2 Intersite In Intersite Out Local Cameras 256 Local Monitors
5. ZSC 500 Installation Manual Issue 02 Page 1 of 10 Support Tel 44 0 161 6437956 email tech support meyertech co uk www meyertech co uk MEYERTECH SECURITY with VISION MEYERTECH UMITED Office Block One Southlink Business Park Oldham OL4 1DE Tel 44 0 161 628 8406 Fax 44 0 161 628 9811 Email technical meyertech co uk http www meyertech co uk INSTALLATION MANUAL for TM ZSC 500 SITE CONTROLLER Whilst every effort has been made to confirm the information in this document is correct MEYERTECH LIMITED cannot accept any liability for any errors omissions and or incorrect information contained within this document No part of this document may be reproduced or distributed in any form or by any means without prior written consent from MEYERTECH LIMITED MEYERTECH LIMITED is committed to continuous product development and therefore reserves the right to change specifications without notice 2000 14 ALL RIGHTS RESERVED ZSC 500 Installation Manual Issue 02 Page 2 of 10 Support Tel 44 0 161 6437956 email tech support meyertech co uk www meyertech co uk CONTENTS CONTENTS ZSC 500 INTRODUCTION ZoneVu ZSC XXXX CONNECTING THE ZSC 500 Unpacking Recommended Cable Connector Table Connection Diagram Intersite Requirements PRODUCT WARRANTY Se NI uv bk A A KR WwW W WNW Whilst every effort has been made to confirm the information in this document is correct ME
6. document is correct MEYERTECH LIMITED cannot accept any liability for any errors omissions and or incorrect information contained within this document No part of this document may be reproduced or distributed in any form or by any means without prior written consent from MEYERTECH LIMITED MEYERTECH LIMITED is committed to continuous product development and therefore reserves the right to change specifications without notice 2000 14 ALL RIGHTS RESERVED ZSC 500 Installation Manual Issue 02 Page 8 of 10 Support Tel 44 0 161 6437956 email tech support meyertech co uk www meyertech co uk EC DECLARATION OF CONFORMITY ACCORDING TO ARTICLE 10 OF COUNCIL DIRECTIVE 89 336 EEC Manufacturer MEYERTECH LIMITED Address Meyertech Limited Office Block One Southlink Business Park Oldham OL4 1DE Declares that the product s Product Code ZSC 500 System Site Controller Model s All Product Options All conforms to the following Product Specifications EN55022 CLASS B EN50093 EN60950 Amendments 1 2 amp 3 1992 Supplementary Information MEYERTECH declare under our sole responsibility that the product to which this declaration relates is in conformity with the protection requirements of council directive 89 336 eec on the approximation of the laws of the member states relating to electromagnetic compatibility when installed in accordance with the instructions given in this manual SK Meyers S K MEYERS Managing Direc
7. ly 12V Connect up the ZSC 500 in accordance with diagram shown Looking at the back of the rack pin number one is on the left on the 2 part 6 way connectors of the ZVM ZVK and ZVR ports Recommended Cable RS422 Half Duplex connections Beldon 2 pair 9842 or 9502 RS485 Half Duplex connections Beldon 1 pair 8761 RS422 Simplex connections Beldon 1 pair 8761 Connector Table NAME CONNECTOR POWER 12V power jack SITE IN 9 way D type plug SITE OUT 9 way D type socket PC 1 9 way D type plug PC 2 9 way D type plug ZoneVu 6 way 2 part ZVR 1 6 way 2 part ZVR 2 6 way 2 part CAMERA CONTROL 2 RS422 or RS485 Doo l lM Whilst every effort has been made to confirm the information in this document is correct MEYERTECH LIMITED cannot accept any liability for any errors omissions and or incorrect information contained within this document No part of this document may be reproduced or distributed in any form or by any means without prior written consent from MEYERTECH LIMITED MEYERTECH LIMITED is committed to continuous product development and therefore reserves the right to change specifications without notice 2000 14 ALL RIGHTS RESERVED ZSC 500 Installation Manual Issue 02 Page 5 of 10 Support Tel 44 0 161 6437956 email tech support meyertech co uk www meyertech co uk Connection Diagram D AAA ZSC 500 rear panel connector view 01 first release 02 Second ZVR port added RS485 RS485 3 Rx Tx 3 Rx Tx 4 Rx Tx
8. nnection Yes Total sites 99 limitations when running in simplex mode contact Meyertech for further details Baud Rates The site controller will communicate with other site controllers at various baud rates Baud rate Usage 9600 Small installations 19200 gt 8 sites 38400 As required 57600 As required Turnaround Time Turnaround time is the time taken for transmission equipment to finish receiving data before it starts transmitting Similarly the time taken from finishing transmission to when it goes high impedance For connecting to 3 party transmission equipment our referenced turnaround time should be treated as their maximum turnaround i e 3 party must be faster than Meyertech On some equipment the minimum turnaround time is determined by baud rate i e if the site controller is running at a slow baud they must not have too fast a turnaround as it could turn mid bit Baud rate Turnaround time ms 9600 4 19200 3 38400 2 57600 1 RS485 Interface e RS485 e 2 wire e Half duplex e 2 connectors provided to assist daisy chaining e Un terminated e Un biased e Pre biasing can be achieved by using the 750R pull up resistor provided on pin 8 on the Intersite Out port in conjunction with an external not provided 750R pull down resistor connected to the Ov connection on pin 5 Whilst every effort has been made to confirm the information in this
9. rtech co uk Whilst every effort has been made to confirm the information in this document is correct MEYERTECH LIMITED cannot accept any liability for any errors omissions and or incorrect information contained within this document No part of this document may be reproduced or distributed in any form or by any means without prior written consent from MEYERTECH LIMITED MEYERTECH LIMITED is committed to continuous product development and therefore reserves the right to change specifications without notice 2000 14 ALL RIGHTS RESERVED
10. tor Meyertech Limited SIGNED ISSUED THIS DAY 20 July 2000 Meyertech Limited Office Block One Southlink Business Park Oldham England OL4 1DE Whilst every effort has been made to confirm the information in this document is correct MEYERTECH LIMITED cannot accept any liability for any errors omissions and or incorrect information contained within this document No part of this document may be reproduced or distributed in any form or by any means without prior written consent from MEYERTECH LIMITED MEYERTECH LIMITED is committed to continuous product development and therefore reserves the right to change specifications without notice 2000 14 ALL RIGHTS RESERVED ZSC 500 Installation Manual Issue 02 Page 9 of 10 Support Tel 44 0 161 6437956 email tech support meyertech co uk www meyertech co uk PRODUCT WARRANTY MEYERTECH UMITED warrants that at the time of shipment the products manufactured by Meyertech will be free from defects in material and workmanship Should any defects appear within twelve months from date of shipment Meyertech shall at it s sole discretion repair or replace the defective material Such material shall not be accepted for return or repair without prior notification of Meyertech Return shipments to Meyertech shall be at the customer s expense Meyertech will return said equipment prepaid via best way This warranty is in lieu of and excludes any and all other expressed or implied warranties of
Download Pdf Manuals
Related Search