USER MANUAL
Contents
1. extend the FM antenna 1 Press once to turn gn the radio 2 Adjust the volume by A or A to the desired level 3 If you would like to perform manual scanning you can press lt and button to fine tune the station by 0 05MHz step or you can press and hold the lt and button to scan next or previous available stations 4 2 Store a favourite station Tune to the station you want to store Press and hold M P0O1 blinks on the screen Press 4 or p to select a preset number Press M to save it Repeat steps 1 5 to store other stations This unit can store 10 presets O O1 R 4 3 Recall a favourite station 1 Press M PO1 blinks on the screen 2 Press or p to select a preset number 3 Press M to confirm 4 4 Setting the Alarm and Alarm Mode 1 In standby mode Press and hold the A until the numbers flash 2 Press the HR and MIN to set the hours and minutes 3 Press the then press the or to select whether the alarm will use the buzzer bb or the FM radio frequency shown 4 Press the to confirm the selection The Alarm 1 indicator which is on the face of the unit lights up PRISM Note To turn off alarm or change alarm type at any time use steps 3 amp 4 4 Same procedure applies for alarm 2 with A button If you wake up with the radio select your desired station then long press 4 Button to turn off the radio For2. Alarm Radio with USB Charging Avoid the following locations e Where it is exposed to direct sunlight e Where itis close to heat radiating sources e Where the humidity is high and ventilation is poor e Where it is dusty Adjusting the Aerial Fully extend the aerial to ensure good reception in FM Radio modes It may be necessary to alter the position of the FM Alarm Clock Radio and or the aerial to achieve the best signal 2 H o _ Extend wire antenna Prism 2 2 Left View Q Snooze Dimmer Button Standby NaP Memorization Tune down Previous Tune up Next 2 3 Right View Q Alarm 1 Volume up Alarm 2 Volume down Setting the clock Minutes setting Hour setting 2 4 Front View 9 0066 NAP LED Indicator USB charger 1 USB charger 2 Sleep LED indicator Alarm1 LED Indicator Alarm 2 LED Indicator PM LED indicator 2 5 Rear View 6 DC In socket Goodmans Prism 3 Quick Setting up 4 3 1 Power on and install the back up batteries 1 Insert the plug of power cord into a standard wall outlet 2 Install the backup batteries in their compartment Use only the size and type of batteries specified 2x AAA Respect the polarity indicated in the compartment Improper polarity can cause damage to the device Do not attempt to recharge the batteri
3. a St Li als MODEL GCRUSBO3 FM ALARM CLOCK RADIO WITH USB CHARGING USER MANUAL Goodmans 1 Welcome 4 2 Your FM ALARM CLOCK RADIO 2 1 In The Box 2 2 Left View 2 3 Right View 2 4 Front View 2 5 Rear View 3 Quick Setup 3 1 Power on or install the batteries 3 2 Setting the clock 3 3 Tuning the Radio 3 4 Adjusting the Volume 3 5 To set Alarm 1 4 Features 4 1 Tune the radio 4 2 Preset the station 4 3 Listening to station presets 4 4 Setting the Alarm and Alarm Mode 4 5 Stopping the alarm 4 6 Sleep Function 4 7 NAP Function 4 8 Dimmer 4 9 USB Charge out 5 Troubleshooting 6 Technical Specifications Welcome Thank you for choosing this Goodmans product We ve been making electronics for the British people for 70 years Each of our projects has been carefully designed to be great at what it does and this one is no exception We hope you enjoy your new FM Alarm Clock Radio with USB Charging Your FM Alarm Radio with USB Charing In The Box Carefully remove your FM Alarm Clock Radio from the box Inside the box you will find e FM Alarm clock radio with USB Charging e Mains power supply lead Quick Start Guide Guarantee Booklet Mains Power Your FM Alarm Clock Radio with USB Charging equires a mains supply of 230V AC 50 Hz Please ensure that yrour mains supply is compatible before use Disconnect the Power Cord from the mains when not in use Position of FM
4. es they can catch fire or explode Backup System All settings are memorized however the clock time could occasionally need to be readjusted In case of power failure if backup batteries are not installed the screen will flash to indicate this power failure and the necessity to redo your settings TURN ON OFF THE FM RADIO In standy mode press button once to turn on the FM Radio Long press this button again to turn off the FM Radio 3 2 SETTING THE CLOCK 1 Press and hold the until the numbers flash 2 Press the HR and MIN to set the hours and minutes 3 Press the to set the selected time 3 3 TUNING THE RADIO Press and hold the 4 or to search for a radio station 3 4 ADJUSTING THE VOLUME Press A or A to adjust the volume level Prism 3 5 TO SET ALARM 1 1 Press and hold the until the numbers flash Press the HR and MIN to set the hours and minutes 3 Press the A then press the or to select whether the alarm will use the buzzer bb or the FM radio frequency shown 4 Press the to confirm the selection The Alarm 1 indicator which is on the face of the unit lights up Nh Note To set a second alarm follow the same instructions using To turn off alarm or change alarm type at any time use steps 3 amp 4 Features LISTENING TO RADIO 4 1 Tune the radio To enhance radio reception ability
5. splayed 4 8 Dimmer Press Snooze Dimmer button to select the brightness of the screen high or low 4 9 USB Charge out You can charge your devices via the USB1 and USB2 socket USB charging for most smartphones PRISM 5 Troubleshooting Problem What do do Check that the AC adaptor is connected No power correctly and mains power is switched on Check the signal strength If the signal strength is low try adjusting the position of the antenna SMO If this doesn t help move the radio to a position where the signal strength is better Check that the alarm s have been set correctly Alarm not sounding If you have set FM presets to wake you check that the alarm volume is set loud enough 6 Technical Specification Model Number GCRUSBO3 ear 230V AC 50 Hz UppIy Adapter DC 5V 1500mA Speaker Output Power Frequency Range FM 87 5 108 MHz Max Power Consuption USB jack DC output 5V 500mA x 2 Goodmans www goodmans co uk PRISM
6. the station selecting please refer to LISTENING TO RADIO The previous level of listening is stored the volume of the alarm will be identical If you wake up with the radio do not forget to check the volume level Press q and or Athen press again If you use the sleep mode with low sound level you should use the buzzer to wake you up 4 5 Stopping the alarm 1 Alarm repetition Press SNOOZE The alarm stops and will sound again 9 minutes later The alarm indicator will flash 2 Alarm stop Press or fl The alarm 1 will sound again the next day at the same time 3 Alarm Cancellation In standby mode press A and use or pto select OFF to cancel the alarm permanently Note Same procedure applies for alarm 2 with A button 4 6 Sleep Function To fall asleep with the radio Press turn on the radio then press to select 120 90 60 30 15 10 or 5 minutes of listening Indicator 25 lights up The unit will automatically turn off after the specified time To cancel the sleep function repeatedly press button until OFF display or Long press button until indicator lights off 4 7 NAP Function This function wakes you up after a short period of time Only the buzzer may be selected 1 In standby mode press 2 to select 120 90 60 30 15 10 or 5 minutes for your nap The indicator lights nap 2 To stop the alarm press 2 3 To cancel the function press gt repeatedly until OFF is di
Download Pdf Manuals
Related Search