CODE-2641 Series USER MANUAL
Contents
1. Other Products In The Range xexe CODE ME12 CODE MS12 CODE ME24 CODE MS24 CODE 6800 CODE FC02 CODE MFO1 Description 1 or 2 door controller with Ethernet connection a 1 or 2 door controller with Serial connection 2 or 4 door controller with Ethernet connection 3 2 or 4 door controller with Serial connection 5 Amp Power supply in Metal Box Enclosure Card Distributor Mifare Card CO d IPIT IEE Vandal Resistant Reader USER MANUAL coze ACCESS CONTROL Product Specification Notes For Installation Name Qty Note For the reader cable connection to the CODE Controller CAT 5 cable or 8 core twisted pair cable can be used CODE 2641 1 Vandal Reader User manual User Documentation Screw driver The reader is normally installed at the right side of the door outside at a height O20 COM SPECIET REOQE of 1 4m from the floor and 3 5 cm from the door frame with the exit button Rubber plug 2 mmx30 mm used for fixing inside also at a height of 1 4m off the floor Self tapping screws 2 04mmx28 mm used for fixing The reader should not be installed against a metal surface If this can not be avoided either the metal surface should be removed with only the fixing area remaining or an isolation material thicker than 10cm should be placed between the reader and the metal surface The Cont2. eration of the LED changing to Green connect the Yellow Buzzer wire to BUZ on the controller Concept What should I do 7 1 Card not recognised by reader e Check whether the Data transmission connections of DATA 0 and DATA 1 are correct e Check that the distance between the controller and the reader is no longer than 60 metres Wiegand 26 bit If so reduce the distance between the controller and the reader e Check the RD OK Reader signal OK LED ok goes green when an ID device is presented to the reader e Check the power on the reader power wires is within 10 5v DC and 12 5v DC 7 2 If the lock does not operate e Check whether the connections of the readers exit buttons and electric locks are wired correctly e Check if the output of the relay switches and the relay operation LED switches on e Check if the power is being switched to the lock e f there is no switching of the relay then check the reader and the wiring e Check the access software programming 7 3 If the Reader does not operate after a power down e Please perform a controller download from the CODE Access Software
3. roller to reader length should not exceed 60 metres using CAT 5 cable Material Metal Operating Voltage 9 16V DC _ nr Output WG 26 Please observe reader power polarity when connecting to the access controller Card type Mifare Reading Distance 2 4 cm Communication Distance 60M Reader Parameters Idle Current lt 80MA Operating Temperature 45 C 60 C Operating Humidity 10 70 RH Reader Radio Frequency 13 56 MHz Waterproof Conforms to IP68 Card Identification Mode MF card Dimension 120X56X18 mm Sensing Distance MF Card 2 4cm Reader Data Output Wiegand 26 Bit Reading Speed lt 0 1s Installation Procedure Wiring Connections Remove the back cover from the keypad using the supplied special screw driver Connect with controller LED BUZ input on controller Connect with controller beeper WG output line DO Gently pull the metal back plate cover away from the main body of the reader WG output line D1 Power supply 12V Drill 2 holes on the wall for the Self tapping screws and I hole for the cable Put the supplied rubber bungs to into the two holes Fix the back cover firmly on the wall with 2 Self tapping screws Thread the cable through the cable hole connect the wire needed wrap unused wire with insulating tape isolated to prevent short circuit Note Attach the keypad to the back cover Power supply GND To activate the sounder during the op
Download Pdf Manuals
Related Search