Operating instructions Retro-reflective sensor OGP50x 704072 / 01
Contents
1. K Remove the object see figure 2 and press OUT on The settings can also be carried out first without object and then with object 4 3 Programming unsuccessful gt LED flashes quickly 8 Hz Possible causes e Measured value difference too small e Max programming time of 15 min exceeded 4 4 Setting of maximum sensitivity gt Align the sensor so that no light is reflected The sensor is to switch when the object is detected gt First press OUT on and then OUT off The sensor is to switch when the object is not detected gt First press OUT off then OUT on 4 5 Locking or unlocking the buttons The unit can be locked electronically to prevent unintentional settings Press OUT on and OUT off simultaneously for 10 s gt Acknowledgement is indicated by a change of the LED status 5 Operation K Check whether the unit operates correctly gt The LED lights when the switching output is switched 6 Maintenance K Keep the lens of the sensor free from soiling K For cleaning do not use any solvents or cleaning agents which could damage the plastic lens Technical data and further information at www ifm com2. Ce 06 2011 704072 01 ifm electronic Operating instructions Retro reflective sensor efecborzoo OGP50x 1 Functions and features In conjunction with a prismatic reflector or reflective tape the retro reflective sensor detects objects and materials without contact and indicates their presence by a switching signal Range 0 03 5 m on prismatic reflector 80 mm E20005 2 Installation O 0 LE E E 5 5 5 5 5 5 5 5 5 5 u 5 cl gt Fit the prismatic reflector or the reflective tape behind the object to be detected gt Align the retro reflective sensor to it and and secure it to a bracket Maximum range only with accurate alignment 3 Electrical connection gt Disconnect power Connect the unit as follows Cable Connector Pinconnection lad BK pin4 Core colours BN brown BU blue BK black 4 Operating and display elements 1 LED 2 OUT off 3 OUT on 4 Settings 4 1 The sensor is to switch when the object is detected gt Position the object eg K Press OUT on for 2 s gt The sensitivity is set to the object gt The LED flashes Q O Us ee or o 5 Press OUT off gt The sensitivity is set without object gt The LED goes out The programming is finished Remove the object 4 2 The sensor is not to switch when the object is detected gt Position the object see figure 1 and press OUT off for 2 s
Download Pdf Manuals
Related Search