External display from FLARM EDIATec GmbH Installation Manual
Contents
1. external display can be plugged in a Y adapter is needed This adapter is plugged in directly into the FLARM and then offers 2 plugs for the connection of the 2 cables All FLARM and external display versions work together perfectly The Y adapter RJ11 12 3 plug openings and RJ45 2 plug openings and 1 plug are standard telephone accessories Additional 4 pole cables and optional Y adaptors can be ordered from EDIATec Pin Connections not used 3 VDC GND RX external display receives data TX external display sends data not used OonhkWN Drawing of back of external display The supplied 4 pole cable as well as the Y adapter are wired 1 1 pin 1 of plug 1 connected to pin 1 on plug 2 etc Technical data o Weight 11 g without cable and adapter o Size 25 x 50 x 4 7 mm exkl RJ11 Plug approx additional 10 mm to the rear o Power 3 VDC from FLARM typical drain 30 mA bei 3 V 90 mW EDIATec refuses any warranty claims resulting due to incorrect installation and any claims outside the warranty2. External display from FLARM EDIATec GmbH Installation Manual Schwandstrasse 15 A V 5 1e 18 04 2011 3634 Thierachern www ediatec ch Switzerland display ediatec ch Installation of the external Display The display is supplied with a double sided sticky tape which is suitable for a clean and flat surface The glue cures within 24 hours If used ona rough surface a thicker and spongy sticky tape should be used The display should be mounted in such a manner that the pilot can view it easily that he can hear the acoustic signal and that he can reach the button Mode Minimum compass distance 25 cm To An opening of 16 x 16 mm for the cable is needed on the instrument x panel see drawing Opening dimension Connection with FLARM For the electrical connection the supplied 4 pole cable with a plug for the external display and a RJ11 12 plug for the FLARM should be used FLARM 05 06 RJ11 12 small plug with 4 6 pin Power PC Wiring one seater FLARM 05 06 RJ11 Adapter If in a two seater 2 external displays are to be installed the 2 displays should first be connected to each other by means of a Y adaptor RJ11 4 poles With help of the 4 pole cable this adapter 7 is then connected to the FLARM Ru11 12 see Aing tWo seate drawing The FLARM Hardware version 1 2004 are only equipped with one RJ45 plug To ensure that the power supply cable to the FLARM and the connection to the
Download Pdf Manuals
Related Search