User Manual - e
Contents
1. 3 Shown lt 9 gt push the lockstitch according to the arrow direction There are two levels for you to adjust the handlebar height The height limiting hole was shown in lt 10 gt Press the T conduit pinball if it pop out when adjust the height Lock the lockstitch back after adjustment Operation 1 Introduction of Handlebar parts 0048 0 B 1 Thumb Accelerator 2 Thumb Electronic Magnetic Brake 3 Switch Button 4 Setting Button 5 Mode Button 6 Horn Button 7 Led Headlight 8 Handlebar Fold Button 9 Display 2 Operating Instructions a ON OFF lt D gt Press the switch and the display lights indicate power on It will turn off after unused for 3minutes b Speed control lt D gt Press the right thumb accelerator to control the speed 1 23km h c Braking Control Press the left thumb electronic magnetic brake The greater angle you press the greater braking force will be d Horn lt D gt Turn on the power press the horn button and it will hoot e LED Headlight Press the LED headlight button when need and there will be a sign in display indicates the light is turn on Press the button again when you do not need the light f Mileage Show When power off it shows time When power on it displays three modes total trip and time You can press the mode button to change it When it displays the trip mode press the setting button for 3 seconds and it will clear the trip Singl2. E TWOW User Manual www e twow at Thank you for purchasing our products For your convenience please carefully read the user s manual and warranty book before using this product Safety 1The product is for adults only limited one adult please do not carry two adults at the same time Prohibit use by minors 2Please wear your safety helmet and other protective equipment when riding 3Do not ride in traffic lane or unsafe and violate local regulations place 4 Please exercise in broad areas and ride after skilled manipulation do not ride in traffic lane 5 Do not make any dangerous actions when riding or riding with one hand Keep your feet on the scooter 6 Do not attempt to across the stairs which above 3 cm directly it may overturn the scooter causing injury or damage For less than 3 cm step should try to avoid too 7 The scooter s highest speed is 23km h For your safety please limit the speed within 20km h Please try to avoid using at night if needed please limit the speed within 15km h or less and turn on headlight 8 Do not use the scooter when the temperature lower than 5 C 9 Please slow down or get off when riding in rough or poor road conditions 10 Do not ride the scooter in oil or ice surface terrain 11Please adjust the height of handlebar to the appropriate location according to your height to ensure riding safety 12Do not immerse the scooter in the water with the depth of 4 cm or directly inje
3. cted by the water to avoid damage of the electrical part of the vehicle 13Please try to avoid riding in bad weather such as heavy rain and high winds to protect it from unnecessary factors that cause unnecessary harm Products 1 Use Unfold and Fold a Fold Illustration Push lt 3 gt _ Press SS a lt 6 gt 1 Use Unfold and Fold a Fold Illustration 1 Shown lt 1 gt open the lockstitch according to the arrow direction 2 Shown lt 2 gt press the T conduit pinball in the red circle press the handlebar to the location shown in lt 3 gt at the same time then lock the lockstitch to the original place shown in lt 1 gt 3 Hold the handlebar with both hands press the pinball in the red circle down firmly as shown in lt 4 gt Pull out the handlebar to the maximum according to the arrow direction shown in Figure lt 4 gt then fold them downward and it will be like B 4Push the handlebar forward press or stamp the silvery white folding wrench according to the direction shown in Figure lt 6 gt at the same time It will be fold after that shown as C b Unfold Illustration a_ lt P 1 Shown lt 7 gt push the silver white folding wrench to expand the body and push lt 8 gt lt 9 gt lt 10 gt forward the grip at the same time to make the sustain hook plate back to place 2 Shown lt 8 gt push the handlebar according to the arrow direction and then the handlebar will back automatically
4. e stroke accumulated more than 100 belongs to 100 g Emergency Emergency stamp the rear foot brake can simultaneously achieve front electronic magnetic brake and rear wheel friction brake under normal circumstances please do not use the emergency brake at high speed to avoid the wheel damage and the company shall not be responsible for this damage Please repair it for pay 3 Display Factory Setting Press setting button and mode button at the same time for 3 seconds four numbers will flash at the bottom right of display Press the setting button to change the number location and press the mode button to change the number from0 9 Set the number 0624 according to this method front wheel perimeter is 0624mm After this press the setting button again and the sign km h will flash press the mode button to change m h to km h Press the setting button at last and the settings will be finished 0000 Light shows Speed shows Battery shows From up to down total trip Different number in different mode Riding Operation Ready 1 Choose a suitable venue for riding 2 Expand the scooter in accordance with the description 3 Adjust the T pipe to the suitable height according to your height Start 1 Press the power button to turn on the power 2 Stand on foot on the scooter and leave another foot on the ground 3 Gently press down on the right thumb accelerator the scooter will immediately move forward slow
5. ed do not fit the actual values Reason Parameters are set incorrectly or missing Solution Please reset the display factory settings following the instructions 3 Digital display dim Reason Bad battery contacts or the battery is dead Solution Turn off the power then restart again if the problem still occurs please contact your local reseller When the product does not operate normally check the following work is completed or not a Turn on the battery b Check the battery via the display if there is electricity c Left thumb electronic brake and rear brake in place d All jacks and connectors holes linked accurately If the above steps are completed the product still does not operate normally please contact your local vendor or reseller Product Specification Sheet E TWOW Specifications Overall Expand Size 940 1160 135mm Overall Fold Size 945 300 135mm Scooter Weight 9 8KG Top Speed 23km h Grade Ability 15 degree slope Single Life 20km varied from weight wind speed roap conditions temperature and other factors Battery Type Li po Lithium Battery Battery parameters Battery Capacity 5 8AH Motor type Brushless DC Motor Rated Output Power 250W Capability Rated voltage 24V Maximum output torque 13 3N m Output Voltage 220V Charger parameters Charging time 2 9 3h Motor parameters Maximum Rotational Speed 700r min
6. edicated charger which has a charging protection function when the battery is 100 charged the charger will automatically stop charging Charging time is no more than 3 hours Due to water collision and other non normal factors that lead to battery damage which is not covered under warranty Charge Description Open the charging hole rubber protective cover put the charger connector into the charging hole Connect the charger plug into the power socket It means it is charging when charger light is red charger light turns green when the battery is fully charged Maintenance Lubricating Please add a small amount of grease or lubricants to handle folded position every six months Please check scooter every three months weather the screws are loose if yes screw it Battery The lithium battery provide by company can be recharged at least 500 times the normal use can reach more than 1 000 times Every time after fully charged the lithium battery needs to be replaced if the travel distance is too short Placement and daily care Do not exposure the scooter under the sun for too long or other serious damp places Please keep the scooter clean General Troubleshooting Checklist When the products have any problems please refer to the following methods 1 LED display black screen Reason Exposure under the sun for too long Solution Place it in shadow and it will return to normal after a period 2 Values appear
7. ly Place the foot which is on the floor on the pedal after smooth riding Press the right thumb accelerator the greater the angle you press the faster it will be Brake 1 Under normal circumstances pressing the left thumb electronic magnetic brake the scooter will immediately de energized and then brake The greater the angle you press the greater the braking force will be 2 Emergency stamp the rear foot brake can simultaneously achieve electronic magnetic front brake and rear wheel friction brake under normal circumstances please do not use the emergency brake at high speed Battery and Charger Each E TWOW electric scooter was equipped with a special lithium battery and special smart charger accessories carried by each scooter have a dedicated number please do not use the charger of other brands the charger is not appropriate to other company supplied charger too If the battery or charger is damaged owing to these the company shall not be responsible Battery When you get the E TWOW electric scooter the first time please charge the battery fully before using The battery can be charged at any time in order to ensure that the battery has power during which the battery will not charge for any damage Please charge the battery once every three months if stop using Due to water collision and other non normal factors that lead to battery damage which is not covered under warranty Charger The company provides d
Download Pdf Manuals
Related Search