Installation Manual
Contents
1. Figure Machine 9208 Venture Ct C9 Manassas Park VA 20111 Into figuremachine com www FigureMachine com Installation Manual TCFLOW STACK TCFLOW STACK EXPLODED VIEW A BREATHER SPACER 2 B GASKET STOCK COMPONENT C BACK PLATE 1 D KEYWAY COVER 2 E BREATHER BOLT 2 F BOLT 20 x Ye SOCKET HEAD LOW 3 G O RING 1 H COLLAR AND VELOCITY STACK 1 1 BOLT 20 X 7 16 SOCKET HEAD 3 Dear Customer Thank you for purchasing Figure s TCFLOW STACK Air Cleaner Assembly This Air Cleaner has been engineered to enhance the performance and appearance of your bike for its entire life Proper installation is essential to your overall satisfaction so please read these instructions before attempting to install Exercise patience these instructions are intended to assist even the most mechanically challenged Remember if you are not 100 satisfied with our product simply return it within 30 days of purchase for a complete refund We always love to see installed pictures so we encourage you to email us your best Send to info figuremachine com Package Contents see illustration BREATHER SPACER 2 BACK PLATE 1 KEYWAY COVER 2 BREATHER BOLT 2 BOLT 14 20 x 1 2 SOCKET HEAD LOW 3 O RING 1 COLLAR AND VELOCITY STACK 1 BOLT 4 20 x 7 16 SOCKET HEAD 3 Loctite amp RETAINING COMPOUND 02 oz TroTmoo TCFLOW STACK Installation 1 Remove Stock Filter Ass2. e bolts and then fully tighten the breather bolts 24 Place the O ring in the intake groove of the backing plate Loosely install the 14 20 x 7 16 bolts through the collar and into the backing plate use Loctite on the bolts 25 2 6 Gradually tighten each bolt such that the collar is evenly drawn against the backing plate until all bolts are fully tight and the collar is flat against the backing plate Stand back and enjoy Please send any pictures and or feedback to info figuremachine com
3. embly 1 1 Remove the Allen Cap screw that secures the Filter Cover LU ia 1 2 Remove the three bolts that secure the stock filter Then remove the filter and breather hoses 13 14 1 5 Remove the stock breather bolts and throttle body bolts Remove the stock breather box Carefully remove the stock air filter gasket and set aside for later use Some models Non U S are equipped with an intake valve solenoid If so equipped unhook the connector on the back of the Stock air cleaner The connector of this solenoid will need to be attached to the new filter backing plate and a bypass module not supplied will need to be installed to prevent a check engine light Some models are equipped with a carbon canister vent line If so equipped this hose can be routed to under the bike 2 INSTALL TCFLOW FILTER ASSEMBLY 2 1 Insert three 14 20 x 1 2 LOW head bolts through the backing plate and then through the stock gasket use Loctite on the bolts Loosely install the bolts to the intake but do not fully tighten 2 2 Insert the breather bolts through key hole the backing plate and finally through the breather spacers per the following illustration and then finger tighten to the engine use Loctite on the breather bolts IMPORTANT The end of the spacer with relief goes against the backing plate 2 3 After all bolts from steps 2 1 and 2 2 have been loosely attached fully tighten the 3 intak
Download Pdf Manuals
Related Search