RCC-4CX LITHIUM BATTERY BALANCE CHARGER USER MANUAL
Contents
1. unplug the charger and take out the battery and send it to our distributors or headquarter to repair 7 Keep the vent of cooling fan unimpeded 8 While using put the charger at a stable place and avoid falling down or colliding 9 Before connecting the charge to batteries please notice the positive and negative pole of the battery When the reverse polarity protection beeps please take out the battery immediately The beeps should be stopped in 15 seconds or the charger will be broken 10 For short circuits battery the indicating light of the charger will be off so please stop charging ILLUSTRATION Polar arrangement schematic yo Indicating light for charging status 4 independent units NI 16 8V 12 6V 8V 4N OV AC power input 2cell series socket 2cell balance socket 4cell balance socket 3cell balance socket Cooling fan outlet 2cell balance socket Power cord 2cell series socket RCC 4CX LITHIUM BATTERY BALANCE CHARGER USER MANUAL INSTRUCTIONS Connect the power cord to AC power input on the main body and the power supply socket on the wall Apply to 100 240V alternating current Once the power is on the four indicating lights will turn green and the cooling fan will start running The waiting mode shows ready to charge Charging for DC 14 8V 14 4V 4cell Li ion or Li polymer batteries Insert the adapters of Li ion batteries for balance charging to 4 cell sockets in correct directi2. 4 cell or 3 cell balance charging while making 2 cell charge of series 9 The charger is of the function of supply After the lights turn green the charger will detect voltage of the batteries and give a few more time of charging until the power is full CHARGING COMBINATION Charging 2cell 2cell Acell 3cell 2cell 2cell Charging ti combination series balance balance balance balance series arging time Sanderdmodet 0 Mode2 _ gt _ Medes fo _ gt ___ Beatty capacty 1000mAr0 Medes o _ 0 Using same circuit Battery capacity MUSES X X 1000mA battery quantity using common circuit SPECIFICATION Model RCC 4CX Voltage Input AC 100 240V 50 60Hz Voltage Output 2cell DC 7 4V 3cell DC 11 1V 4 cell DC 14 8V Current Output 1000mA ALIGN CORPORATION LIMITED No 345 SHUI YUAN ROAD FENG YUAN TAIWAN R O C http www align com tw Free service line 0800 000 444 G20138
3. RCC 4CX LITHIUM BATTERY BALANCE CHARGER USER MANUAL ALIGN CE Fe 1 AC 100 240V exchange switch for international specification 2 Apply to 3 6V 3 7V 2 4 cell Li ion Li polymer batteries 3 For both balance charge and charging in series It is a fast convenient design of multiple functions 4 Balance charging is good to prevent the situation of over charging or under charging for a single cell 5 Auto detected charge status display Red light while charging Green light end of charging 6 Cooling fan and multi circuit protection to avoid the dangerous of charging 7 The auto detected function of low voltage for power storage 8 Reverse polarity protection and short circuit protection SAFETY PRECAUTIONS 1 The device is suitable to 2 4cell 1000mAh and more lithium batteries Please do not dismantle or change it for other purpose 2 The battery being in use may be a little hot Please do not charge the battery right away It might cause the battery broken even an accident 3 If there is any unusual deformation of outer casing of battery please do not charge it anymore If the battery becomes hot while charging stop charging and check if the battery is broken 4 Do not use the charger at place near heater or expose of sunshine 5 Do not let this machine drench to the rain water or uses under the heavy moisture in order to avoid the interior short circuits and accidents 6 Prevent liquid and anything into the device If so please
4. ons The 4 indicating lights on the right side will be red showing charging status of each cell Charging for DC 11 1V 10 8V 3 cell Li ion Li polymer batteries Insert the adapters of Li ion batteries for balance charging to 3 cell sockets in correct directions The 3 indicating lights on the right side will be red showing charging status of each cell Charging for DC 7 4V 7 2V 2 cell Li ion Li polymer batteries 1 Insert the adapters of Li ion batteries for balance charging to 2 cell sockets in correct directions You can choose to use one or both sets at one time The 2 indicating lights on the side will be red showing on charging 2 If your 7 4V 7 2V Li ion battery is without a adapter for balance charging use the charging sockets JST adapter on two sides for a charging of series separately 6 When the indicating lights turn green it means charging completed Please remove the batteries 7 If the lights are still green when the batteries connect to the charger it means the batteries are full of electricity The charger will not work on the batteries 8 Standard charging methods 1 Charge one set of 4 cell Li ion battery each time 2 Charge one set of 3 cell Li ion battery each time 3 Charge one or two sets of 2 cell Li ion battery each time p s There are 4 sets of charging circuits in a charger Using one circuit to charge 2 batteries at one time will cause lower current and longer time of charging Do not go for
Download Pdf Manuals
Related Search