Home

AMP2051 User Manual

image

Contents

1. 2 1 Preamplification For each input an individual preamplification factor be tween 0 an 3 can be set Press in the option menu Fup until Function LED1 is on Press now mute Select now with Fup the input and adjust with the encoder the preamplification The Value LEDs show the selected input 2 2 Attenuation of the Outputs For each output an attenuation between 0 and 31 can be adjusted Press in the option menu Fup until Function LED2 is on Press now mute Select now with Fup the 3 FURTHER INFORMATION output and adjust with the encoder the attenuation The Value LEDs show the selected output 2 3 Address of the Remote Control To use the remote control of other devices the address can be set Press in the option menu Fup until Function LED3 is on Press now mute and afterwards any key at the remote control While the device is waiting for a signal from the remote control Value LED2 instead of Value LED1 is on 2 4 Power Up Status When the power supply is switched on the device can enter standby or power up mode To adjust this press in the option menu Fup until Function LED4 is on Press now mute Select now with Fup the mode The follow ing table explains the Value LEDs Value LED Mode 1 standby 2 power up 3 Further Information e At the rec output is the preamplified signal avail able It is independent of volume bass treble and attenuation settings e Only RCS remote cont
2. AMP2051 User Manual Martin Clausen 7 5 2006 1 Main Menu 1 1 Volume Press in the main menu Fup until Function LED1 is on Adjust now the volume with the encoder to the desiered value in the range from 0 to 63 The Value LEDs show the range Value LED Range 4 48 63 3 32 47 2 16 31 1 0 15 1 2 Bass Press in the main menu Fup until Function LED 2 is on Adjust now the bass with the encoder to the desiered value The Value LEDs show the range Value LED Range 3 emphase 2 neutral 1 attentuate 1 3 Treble Press in the main menu Fup until Function LED3 is on Adjust now the treble with the encoder to the desiered value The Value LEDs show the range in the same way as for the bass 1 4 Input Selection Press in the main menu Fup until Function LED4 is on Select now the input with the encoder The Value LEDs show the selected input 1 5 Mute Press the mute button to deactivate the ouputs To acit vate the outputs again press any key 1 6 Standby To toggle between power on and standby mode press in the main menu the standby button 2 The Option Menu To enter this menu press Mute while going from standby to power on mode The standby LED will still be on after entering the option menu Now also a Function LED and a Value LED should be on To leave the option menu press again the standby button The submenus can be left via the mute button
3. rol units are supported This code is supported by most programable remote controls e The device can be reset to factory defaults when the Mute button is pressed while the power is switched on e The remote control is blocked while the option menu is active

Download Pdf Manuals

image

Related Search

Related Contents

JVC DR-MV80B  2 Homepage - VesselTracker  P/NO : MFL67449501(1.0) H Printed in Korea  Livret d`informations - Professionnels à Domicile  STIHL HS 45 - K2 Development Technologies  IP-10K01  57338 Instructions  Mode d`emploi  Acer P225HQbi  2 - Sony  

Copyright © All rights reserved.
Failed to retrieve file