Home

Scope : USER MANUAL TNCN Exe JUNCTION BOX Rev : H Date

1. Scope USER MANUAL TNCN Exe JUNCTION BOX TECHNOR Rev Date Checked by Approved by Page Doc no H 30 08 2013 E T S Gr 1 of 1 51 CNX 5 Marking A certification label is attached to the box ref Fig 1 Handling Precautions have to be taken to avoid damages to the equipment and the individual The enclosure to be packed such that no damage will occure during shipping Installation Dismantling When mounting the enclosure ensure that there is no damages especially inspect the gasket and cover of the equipment Installation to be performed in accordance with standard 60079 14 NEK 420 and or the requirements for the actual installation site NOTE Always read the requirements in the certificate NOTE When plastic window is mounted in the box the box to carry a warning label Text WARNING POTENTIAL ELECTROSTATIC CHARGING HAZARD SEE INSTRUCTIONS Instructions cleaning window with soap and water only The size of entries are from 16 to 100 mm free hole and the quantity is as many as physical possible on the side lid back or bottom top of the enclosure Ensure that there is enough space for the planned cable gland to be mounted and that the gland entrie do not come in conflict with essential parts inside the enclosure Installation of terminals and drilling of new entries only to be performed by skilled persons Label to be marked with maximum voltage and amp rating Check certificate that installation is w
2. ithin the requirements in the certificate Do not connect the box to power source before installation is completed dielectric strength test is performed and lid mounted on box When removing the enclosure the same precautions apply as those observed when mounting the enclosure Lifting lugs If the box is equipped with removable lifting lugs these have after completed installation to be removed and replaced with an Ex approved sealing kit which is to be supplied by BARTEC TECHNOR Inspection Maintenance TNCN enclosures is made of acid resistant stainless steel and thereof not subject to corrosion We recommend that maintenance is performed in accordance with the IEC 60079 17 60079 7 60079 1 1 standards NEK 420 If any damages is found the enclosure should be put out of service and the manufacturer contacted Further technical informations is available on www bartec no Fig 1 Type BARTEC HZA BARTEC fier STAVANGER NORWAY Use STAVANGER NORWAY C E oso 3 T2GExeb CT Gd DNV 2001 0SL ATEX 176X C E070 T2DExDANZ T C DNV 2001 0SL ATEX 0176X ExebICT Gb IEC Ex DNV09 0004X ExtDA21 IT IECEx DNV09 0004X DO NOT OPEN WHEN ENERGIZED DO NOT OPEN WHEN ENERGIZED

Scope : USER MANUAL TNCN Exe JUNCTION BOX Rev : H Date

Contents

Download Pdf Manuals

Related Search

Related Contents