10BASE-FB Transceiver Module 3C12067 User's Guide Limited
Contents
1. Functional PLS amp AUI Specification ISO 8802 3 Sect 7 Safety UL1950 EN60950 CSA22 2 950 IEC 825 PFI EN55022 Class B BN50082 1 FCC Part 15 Class A CSA C108 8 Class A Environmental IEC68 Radio Interference Statement This equipment has been tested with a class A computing device and has been found to comply with part 15 of FCC Rules Operation in a residential area may cause unacceptable interference to radio and TV receptions requiring the operator to take whatever steps are necessary to correct the interference This Class A digital apparatus meets all requirements of the Canadian Interference Causing Equipment Regulations Cet appareil num rique de la classe A respecte toutes les exigences du R glement sur le mat riel brouilleur du Canada Copyrights 3CGom and LinkBuilder are registered trademarks and FMS FMSII LinkSwitch SuperStack and MSH are trademarks of 3Gom Corporetion ST is a registered trademark of American Telephone and Telegraph Company2. FIRE LIGHTNING OR OTHER HAZARD Limitation of Liability IN NO EVENT WHETHER BASED IN CONTRACT OR TORT INCLUDING NEGLIGENCE SHALL 3COM BE LIABLE FOR INCIDENTAL CONSEQUENTIAL INDIRECT SPECIAL OR PUNITIVE DAMAGES OF ANY KIND OR FOR LOSS OF REVENUE LOSS OF BUSINESS OR OTHER FINANCIAL LOSS ARISING OUT OF OR IN CONNECTION WITH THE SALE INSTALLATION MAINTENANCE USE PERFORMANCE FAILURE OR INTERRUPTION OF ITS PRODUCTS EVEN IF 3COM OR ITS AUTHORIZED RESELLER HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES Some states do not allow the exclusion of implied warranties or the limitation of incidental or consequential damages for consumer products so the above limitations and exclusions may not apply to you This warranty gives you specific legal rights which may vary from state to state GOVERNING LAW This Limited Warranty shall be governed by the laws of Califomia 3Com Corporation 5400 Bayfront Plaza Santa Clara CA 95052 8145 Phone 408 764 5000 Document Number 17 00829 3 Edge Connector 1OBASE FB Ph Header T Transceiver Rx ny g Module Link LED J H 3c12067 n 2 User s Guide gt p This guide provides a general description of the 3Gom 10BASE FB Transceiver Module 3C12067 Keep this guide with your other 3Gom manuals 3 1 Intemetworking Information The 3Com 10BASE FB Transceiver Module Complies with IEEE 802 3 10BASE FB standards m UsesSI type c
3. Page 4 Limited Warranty HARDWARE 3Com warrants its hardware products to be free from defects in workmanship and materials under normal use and service for the following lengths of time from the date of purchase from 3Com or its Authorized Reseller Internetworking products One year Network adapters Lifetime Ethernet stackable hubs and Unmanaged Ethemet fixed port repeaters Lifetime One year if not registered Power supply and fans in these stackable hubs and unmanaged repeaters One Year Other hardware products One Year Spare parts and spare kits 90 days If a product does not operate as warranted during the applicable warranty period 3Gom shall at its expense correct any such defect by repairing the defective product or part or at its option by delivering to Customer an equivalent product or part to replace the defective item All products that are replaced will become the property of 3Com Replacement products may be new or reconditioned Any replaced or repaired product or part has a ninety 90 day warranty or the remainder of the initial warranty period whichever is longer 3CGom shall not be responsible for any software firmware information or memory data of Customer contained in stored on or integrated with any products returned to 3Gom pursuant to any warranty SOFTWARE 3Com warrants that the software programs licensed from it will perform in substantial conformance to the program specifications for a period of ninety 90
4. ce for software products may be obtained by telephoning 3Com s Corporate Service Center or an Authorized 3Gom Service Center within the warranty period Products retumed to 3Com s Corporate Service Center must be pre authorized by 3Com with a Retum Material Authorization RMA number marked on the outside of the package and sent prepaid insured and packaged appropriately for safe shipment The repaired or replaced item will be shipped to Customer at 3Com s expense not later than thirty 30 days after receipt by 3Gom WARRANTIES EXCLUSIVE IF A 3COM PRODUCT DOES NOT OPERATE AS WARRANTED ABOVE CUSTOMER S SOLE REMEDY SHALL BE REPAIR REPLACEMENT OR REFUND OF THE PURCHASE PRICE PAID AT 3COM S OPTION THE FOREGOING WARRANTIES AND REMEDIES ARE EXCLUSIVE AND ARE IN LIEU OF ALL OTHER WARRANTIES EXPRESS OR IMPLIED ETHER IN FACT OR BY OPERATION OF LAW STATUTORY OR OTHERWISE INCLUDING WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE 3COM NETHER ASSUMES NOR AUTHORIZES ANY OTHER PERSON TO ASSUME FOR IT ANY OTHER LIABILITY IN CONNECTION WITH THE SALE INSTALLATION MAINTENANCE OR USE OF ITS PRODUCTS 3COM SHALL NOT BE LIABLE UNDER THIS WARRANTY IF ITS TESTING AND EXAMINATION DISCLOSE THAT THE ALLEGED DEFECT IN THE PRODUCT DOES NOT EXIST OR WAS CAUSED BY CUSTOMER S OR ANY THIRD PERSON S MISUSE NEGLECT IMPROPER INSTALLATION OR TESTING UNAUTHORIZED ATTEMPTS TO REPAIR OR ANY OTHER CAUSE BEYOND THE RANGE OF THE INTENDED USE OR BY ACCIDENT
5. days from the date of purchase from 3CGom or its Authorized Reseller 3Gom warrants the magnetic media containing software against failure during the warranty period No updates are provided 3Com s sole obligation hereunder shall be at 3Gom s discretion to refund the purchase price paid by Customer for any defective software products or to replace any defective media with software which substantially conforms to 3Com s applicable published specifications Customer assumes responsibility for the selection of the appropriate applications program and associated reference materials 3Gom makes no warranty that its software products will work in combination with any hardware or applications software products provided by third parties that the operation of the software products will be uninterrupted or error free or that all defects in the software products will be corrected For any third party products listed in the 3Gom software product documentation or specifications as being compatible 300m will make reasonable efforts to provide compatibility except where the non compatibility is caused by a bug or defect in the third party s product STANDARD WARRANTY SERVICE Standard warranty service for hardware products may be obtained by delivering the defective product accompanied by a copy of the dated proof of purchase to 3Com s Corporate Service Center or to an Authorized 3Gom Service Center during the applicable warranty period Standard warranty servi
6. nel and board edge with the header pins facing down 3 Pass the board of the Transceiver Module through the cut out in the front panel 4 Align the socket on the ECS or MSH Module with the pins on the Transceiver Module and push down finmly to connect Note With the 3C18146 Expansion Module you align the header and pins and press gently to engage the pins Tum the pair over to rest on the Transceiver Module and press finnly close to the header to complete the connection 5 Using the two screws from the blanking plate attach the mounting pane of the Transceiver Module to the module 6 Reinstall the mother device into its chassis and network and power on Connecting the Module After the Transceiver Module is installed 1 Connect two fiber optic cables to the Transceiver Tx and Rx connectors 2 Align the keyways with the bayonets 3 Push and twist until locked Document Number 17 00829 3 T CAUTION Keep the ends of the connectors clean Wipe with a tissue moistened with ethanol if necessary Ensure the other end of the fiber cables are connected to the opposite ports Rx to Tx and Tx to Rx if the cables are marked of a remote 1OBASE FB device If the cables are not marked connect them to a port pair With power supplied to the devices verify that the cables are connected to the correct port by checking that the Link LED lights solid green If the LED is blinking change the fiber cables over to the opposi
7. onnectors m Transrrits and receives Ethemet 10 Mbps traffic over fiber optic cable m Features Link Loss and Jabber indication The Transceiver Module provides an extra port for connectivity to LOBASE FB fiber medium on the following products m SuperStack II Switch 1000 FX and TX 3C16900A and 3C16901A m SuperStack II Switch 3000 FX 3C16940A m SuperStack II Hub 10 s 3C16665A 3C16670A 3C16671A and 3C16672A D LinkBuilder Repeaters 3C16200 3C16210 and 3C16505 m LinkBuilder TP 12 Hub 3C16170 m LinkBuilder FMS Coaxial Stackable Hub 3C1625 0 m LinkBuilder MSH modules 3C18120 3C18124A 3C18146 and 3C18600 Document Number 17 00829 3 2 Installation A CAUTION Only qualified service personnd should install this device Observe normal antistatic precautions Use a grounded wristband A 16 pin header and a 16 way edge connector are mounted on the Transceiver Module for connection to a module stackable hub or repeater The Rx and Tx fiber optic cables terminated with ST bayonet type connectors attach to the fiber optic connectors on the front panel of the Transceiver Module LED Indications The Link LED see figure above indicates the following conditions m Solid Green Connection functioning correctly m 1Blink No light received m 2 Blinks Local jabber m 4Blinks Remote fault m 5 Blinks Invalid data Page 2 Preparing for Installation If you are in
8. stalling the Transceiver Module in a m Hub or repeater Remove the device from the network and all power sources m Module Remove the module from all power sources and the chassis you do not need to power off the chassis m 3C18146 Expansion Module Separate the Expansion Module from its mother module Refer to the relevant user guide or How to Install and Use manual for instructions Remove the blanking plate from the module hub or repeater which is to receive the Transceiver Module Refer to the relevant manual for the plate location Keep the blanking plate in a safe place so it can be replaced if the Transceiver Module is removed Installing in a Stackable Hub or Repeater If you are installing the Transceiver Module in a m FMS stackable or repeater Hold the mounting pane with the pin header side of the board down m SuperStack Il stadkable Hold the mounting panel with the pin header sde of the board up 1 Insert the edge connector end of the Transceiver Module into the rear of the mother device Carefully side the Transceiver Module into the sot and push it all the way in 2 Using the two screws from the blanking plate attach the mounting pane of the Transceiver Module to the back panel 3 Return power to the unit Installing on an ECS or MSH Module 1 Position the ECS or MSH Module on a flat surface with the 16 way socket facing up 2 Hold the Transceiver Module by the mounting pa
9. te ports The Link LED on the Transceiver Module should now light solid green Troubleshooting If the LED is blinking refer to the section LED Indications on page 1 to define the error condition and check the following m Fiber cable connections Tx to Rx Rx to TX m Continuity of the fiber cable m Ceanliness of the connectors m Power status of the remote unit should be powered on If the Transceiver Module powers on but no communication is possible contact your Transceiver Module supplier Ensuring Optical Safety Although the LEDs and Lasers used in this product meet the regulatory requirements for casual exposure to the eye as with any source of bright light it is advised that you do not look into the light source Document Number 17 00829 3 Page 3 IEC 825 Class 1 LED Device For connection only to Class 1 LED Devices aAsSSs1 LED PRODUCT Disdaimer Information in this document is subject to change without notice and does not represent a commitment on the part of 3Gom 3Gom reserves the right to revise or change this document without obligation of 3Gom to notify any person of the revisions or changes Information contained in this document is believed to be accurate at the time of publication but no liability whatsoever can be accepted by 3Gom arising out of any use of this information Standards The 3Gom 10BASE FB Transceiver Module has been designed to comply with the following standards
Download Pdf Manuals
Related Search