Stand-up Paddle User Guide
Contents
1. Cutting Paddle to Length Handle Installation Note Paddle length is a personal preference We recommend the total paddle length to be approxi mately 8 to 12 above head level including the additional length with the handle installed 1 Using the mixing tray and stir stick mix the epoxy thoroughly Alonger length shaft is recommended for racing and flat water cruising A shorter length shaft is recommended for wave riding 2 Coat the inside of the handle with the epoxy Supplies Needed Hacksaw Fine Tip Permanent Masking Tape pt i Sanding Block Dust Mas uaa Grit 5 Minute Epoxy 1 To measure paddle length stand the paddle 3 Insert the handle onto the shaft Line up the flat Sandpaper Stir Stick upright next to you with the tip of the blade touching side of handle with the outward facing blade while the Tape Measure Mixing Tray the ground epoxy is still wet 4 Make sure the front flat side of the handle is perfectly parrallel with the front side of the blade WARNING Once the epoxy dries a crooked handle cannot be straightened 2 Using a fine tip permanent marker mark a line on 3 Wrap a strip of masking tape around the shaft the shaft where you will make the cut where you put your mark to prevent splintering WARNING Make sure to compensate for while cutting the additional length with the handle installed 5 Once the handle has dried drip a bead of epoxy2. as Stand up Paddle User Guide Eu Table of Con Liability Waiver e Release and Waiver of Claims Agreement e Arbitration e Binding Effect of Agreement e Entire Agreement e Assumption of Risk Warnings amp Safety e General Warnings e Important Safety Rules e Weather Condition amp Location Warnings Board Assembl e Installing the Vent Screw e Installing the Center Fin e Installing the Side Fins e Installing a Surf Leash Paddle Assembly e Cutting Paddle to Length e Handle Installation e How to Hold the Paddle Care Maintenance e Cleaning and Storing the Board and Paddle e Caring for a Damaged Board a r 5 i zi w A Pre er y Y Warranty Policy gt ea i d d T a E i A Li i a ee Page 14 va Ja a Page 4 Page 4 Page 4 Page 4 Page 4 Page 5 Page 5 Page 5 Page 6 Page 7 Page 8 Page 9 Page 10 Page 11 Page 12 Page 13 Page 1S Ba Release of Liability Claim Waiver and Assumption of Risk Agreement Release and Waiver of Claims Agreement In consideration of your use of this product you hereby agree to the following to the fullest extent permitted by law 1 To waive any and all claims that you have or may in the future have against Naish International a division of Nalu Kai Incorporated or any of its agents resulting from use of this product and any of its components and 2 To release Naish Int
3. Using the screw slide the metal plate all the way debris before installing the fins forward in the fin box if the fin tab is on the front of the fin OR slide the metal plate all the way back in the fin box if the fin tab is on the rear of the fin 3 Holding the fin at an angle insert the metal pin 4 Keeping the fin at an angle slide the fin into into the fin box opening position 5 Holding the fin firmly push the fin flush with the 6 Using the screwdriver line up the hole in the fin box metal plate with the hole in the fin tab 7 Insert the screw into the fin tab 8 Using the screwdriver tighten the screw into the underlying metal plate naishsurfing com Installing the Side Fins Installing a Surf Leash Note Side fins and fin boxes are not included with all Naish stand up paddle boards Boards that include Note Surf leash is not supplied with board side fin boxes accomodate standard FCS fins WARNING Never use this product without a surf leash A loose Stand up Paddle board in the water is extremely dangerous to you and everyone around you Failure to use a surf leash may result in serious 1 Loosen hex screws before installing the side fins injury or death and make sure the fin boxes and hex screw heads are clean and free of debris Items needed Surf leash Leash string Attaching a leash string to the board 2 Hold the fin firmly and push the base of the fin into the box Push down fi
4. around handle connection to prevent leakage 4 Using the hacksaw cut the shaft 5 Remove the masking tape Using the sanding block sand the end of the shaft flat and smooth out the edge naishsurfing com naishsurfing com How to Hold the Paddle Care amp Maintenance a Cleaning and storing the board and paddle 1 Thoroughly rinse the board surf leash and paddle with fresh water after each use 2 Store the board and paddle in a cool shaded location or room Storing the board and paddle in a hot location or in direct sunlight such as inside a vehicle heated storage room or garage may cause delamination and other serious damage to the board deckpad and paddle 3 Some Naish Stand up Paddle boards include a vent screw The vent screw must be opened on these boards prior to Storing the board for long periods of time Taking them on airplanes or Transporting the boards to high altitudes such as mountain lakes and rivers WARNING Remember to reinstall the vent screw prior to use Failure to do so will result in water damage Caring for a damaged board WARNING Rocks coral sticks and other debris can be hazardous to your board Use extreme caution when carrying or handling your board in areas that may pose a threat of puncture 1 If a puncture does occur immediately leave the water and discontinue use until the board has been professionally repaired Failure to do so may cause delamination and other s
5. age or it will be refused 4 If a product is deemed to be defective by Naish the warranty covers the repair or replacement of the defective product only Naish will not be responsible for any costs losses or damages incurred as a result of loss or use of this product 5 This warranty does not cover damage caused by misuse abuse neglect normal wear and tear including but not limited to punctures damage due to excessive heat exposure damage caused by improper handling and storage damage caused by use in waves or shore break board breakage caused by falling or crashing in surf conditions or damage caused by anything other than defects in material and workmanship 6 This warranty is void if any unauthorized repair change or modification has been made to any part ofthe equipment 7 The warranty for any repaired or replacement equipment is good from the date of the original purchase only 8 The original purchase receipt must accompany all warranty claims The name of the retailer and date of purchase must be clear and legible 9 There are no warranties that extend beyond the warranty specified here in naishsurfing com An u i naishsurfing com
6. erious damage to the board 2 Take your board to a professional surfboard repair facility or your local Authorized Naish Dealer for repair assistance 3 If you attempt to repair the board on your own epoxy resin MUST be used for the repair DO NOT use polyester resin to repair any Naish Stand up Paddle board Blade Blade Facing Facing Forward Backward gt gt gt Correct Incorrect gt a a E gt 2 ta a i en N naishsurfing com naishsurfing com Warranty Policy Naish warrants this product to be free from major defects in material or workmanship to the original purchaser for a period of one year from the date of purchase This warranty is subject to the following limitations 1 The warranty is valid only when the product is registered online at www naishsurfing com within seven 7 days from the date of purchase 2 The warranty is valid only when this product is used for normal recreational activities and does not cover products used in rental or school operations 3 Naish will make the final warranty determination which may require inspection and or photos of the equipment which clearly show the defect s If necessary this information must be sent to the Naish distributor in your country with prepaid postage Product can be returned only if a return authorization number is given in advance by the Naish distributor The return authorization number must be clearly labeled on the outside of the pack
7. ernational a division of Nalu Kai Incorporated or any of its agents from any and all liability from any loss damage injury or expense that you or any users of this product may suffer or that your next of kin may suffer as a result of the use of this product due to any cause whatsoever including negligence or breach of contract on the part of Naish International a division of Nalu Kai Incorporated or any of its agents in the design or manufacture of this product Arbitration In further consideration of the sale to you of this product and any of its components you hereby agree to submit to binding arbitration any and all claims which you believe you may have against Naish International a division of Nalu Kai Incorporated or any of its agents arising from the use of any of the Naish International a division of Nalu Kai Incorporated equipment The arbitration shall be pursuant to the rules of the American Arbitration Association Arbitration shall be commenced within one 1 year from the date on which any alleged claim first arose Further the arbitration shall be held in Maui Hawaii unless otherwise mutually agreed to by all parties The submission to the American Arbitration Association shall be limited and the arbitration award may be enforced by any court of competent jurisdiction Binding Effect of Agreement In the event of your death or incapacity this Agreement shall be effective and binding upon your heirs next of kin exec
8. rd in windy conditions may result in serious injury to yourself and others around you 5 Never use this product in thunderstorms and lightning conditions 6 Never use this product in conditions that are beyond your ability such as but not limited to high surf riptides currents or river rapids 7 Never use this product near other boat traffic or watercrafts 8 Never use this product near crowded beaches or waters naishsurfing com Installing the Vent Screw Note Vent screw is not supplied with all models WARNING Select Naish Stand up Paddle board models include a vent screw The vent screw MUST be installed on these boards prior to use Failure to do so will result in water damage 1 Make sure the vent screw hole is clean and free of debris before installation Note Select boards may also include a M8 insert behind the vent screw The M8 insert will accomodate a universal mast base for a windsufing sail and rig The M8 insert is sealed and does not require a screw plug 2 Make sure supplied vent screw has rubber ring attached 3 Tighten the vent screw straight 4 Make sure the vent screw is installed firmly to avoid water leakage but do not overtighten 5 Remove the warning sticker EN naishsurfing com Installing the Center Fin Note Use a flat head or Phillips head screwdriver to install the supplied fin metal plate and screw 1 Make sure the center fin box is clean and free of 2
9. rmly until the fin is flush with the board 1 Fold the leash string in half and 2 Thread the loop through the 3 Pull the loop up even with the tie the ends together leash plug knot 3 Insert the hex screw key all the way into the hex screw head to avoid stripping Attaching a surf leash to the board gt a ij 4 Tighten the hex screws down against the two 1 Open the Velcro leash 2 Close all Velcro flaps securely 3 Press on the board and pull osts i attachment and feed the flap on the leash simultaneously as through the leash string shown to insure the leash WARNING DO NOT over tighten the hex screws Over tightening can cause damage to your fin system The hex screws only need to be snug enough to hold a fin securely attachment is secure Attaching a surf leash to your ankle 5 Check to see that the fin is secure by grabbing the top third of the fin lightly try to wiggle it out of the box If you are able to pull the fin out of the box you will need to tighten the hex screws a little more WARNING DO NOT over tighten the hex screws Over tightening can cause damage to your fin system The hex screws only need to be snug enough to hold an FCS fin securely 1 Open the Velcro ankle 2 Close all Velcro flaps securely 3 Pull on the leash to insure the attachment and wrap the flaps ankle attachment is secure snug around your ankle EM naishsurfing com naishsurfing com J
10. safety and the safety of others around you when using this product 5 If you are under the age of 18 you must have a legal guardian read these warnings and safety precautions Do not use this product without adult supervision 6 Do not use this product if you are under the influence of alcohol drugs or medications Important safety rules 1 Before using this product the user should take lessons from a certified school This product should not be used by anyone who is not experienced with stand up paddling 2 Always wear a Coast Guard Approved personal flotation device when using this product This product is not a personal flotation device 3 Never use this product without a proper surf leash A loose stand up board in the water is extremely dangerous to you and everyone around you Failure to use a surf leash may result in serious injury or death 4 Examine your surf leash after each use and replace it if you see any sign of wear 5 Always wear a helmet and booties when using this product 6 Always paddle with an experienced partner when using this product Weather condition amp location warnings 1 Always observe Coast Guard rules and regulations when using this product 2 Never use this product in offshore wind conditions 3 Never use this product in more than 10 knots of wind Using this product in windy conditions may result in serious injury or death 4 Use caution when carrying this product Carrying the boa
11. utors administrators assigns and representatives Entire Agreement In entering into this Agreement you are not relying upon any oral or written representations other than what is set forth in this agreement and User s Guide Assumption of Risk By purchasing using and assembling this product you are agreeing to 1 Be bound to the terms set forth below and 2 Require anyone using this product to be bound by such terms If you are unwilling to be bound by these terms return this product before use for a full refund Use of this product and any of its components involves certain inherent risks dangers and hazards which can result in serious personal injury and death In using this product you freely agree to assume and accept any and all known and unknown risks of injury while using this equipment The risks inherent in the sport can be greatly reduced by abiding to the Warning and Safety Precautions listed in this User Guide and using common sense naishsurfing com Warning and Safety Precautions General warnings 1 Stand up Paddling is a dangerous sport Use of this product exposes the user to unexpected risks dangers and hazards 2 Always use extreme caution when using this product Never act in a careless manner when using this product Misuse of this product may result in serious injury or death 3 Only use this product if you are in good physical health and know how to swim 4 You are responsible for your own
Download Pdf Manuals
Related Search