Operating instructions ClassicLine module
Contents
1. CE 07 2008 1390737 O0 ifm electronic Operating instructions AS interface ClassicLine module AC5245 Contents 1 Functions and features 3 2 Operating and display elements 3 SA LH EL LI E LACS EEE erehieteveniertanes 4 4 PO CICSSING sosin nina scons nasiar awe sam nmn sean nactaihnhebedmntsiindnadinsnasananamadeneesatdinmes 9 4 1 Addressing with the AC1144 addressing unit 9 5 Electrical connection ss 9 Le 61110 L EE RE NE 10 1 Functions and features e Maximum number of modules per master 62 e Ao interface version 3 0 downward compatible 2 Operating and display elements addressing interface 4 M12 sockets LED labels LED PWR fr ehY gt Scale drawing 3 Installation Alignment of the flat cable on delivery Carefully place the yellow AS i flat cable into the profile slot Mount the upper part Lock the unit With the supplied lower part the flat cable can be aligned in three directions For the requested direction place the flat cable guide 1 accordingly Settings at the lower part select the position 1 2 or 3 depending on the requested flat cable alignment gt A factory setting Settings at the upper part Then set the selected position at the upper part To do so turn the triangle to the corresponding number fig D1 and D2 Use a tool e g a screwdriver figure D1 or the yellow black flat2. cable guide figure D2 Open the unit Open the unit using a tool as shown e g screwdriver Take care in laying the AS i flat cable the flat cable should be laid straight for about 15 cm 4 Addressing The address is set to 0 at the factory 4 1 Addressing with the AC1144 addressing unit When mounted and wired the module can be addressed with the addressing cable E 0213 via the integrated addressing interface lf a slave with the extended addressing mode is used in combination with a master of the first generation version 2 0 an address between 1A and 31A must be assigned to this slave UK 4 inputs AS i profile S 0 A E extended addressing mode yes Databit Do Inputs 5 Electrical connection Connect the plugs of the sensors to the M12 sockets To guarantee protection rating IP 67 e cover the unused sockets with protective caps E73004 tightening torque 0 6 0 8 Nm e the flat cable end seal E70413 must be used if the module is at the end of the cable line to be ordered separately 6 Operation Avoid build up of dirt and dust on the upper and lower parts so that the locking mechanism is not affected e LED yellow input output switched e LED PWR green AS i voltage supply ok e LED FAULT red lights AS i communication error slave does not participate in the normal exchange of data e g slave address 0 e LED FAULT red flashes peripheral fault e g sensor supply
3. output overloaded or shorted Overload and short circuit of the input supply and the outputs are signal led as peripheral fault to the AS i master version 2 1 or higher 7 Technical data Technical data and further information at www ifm com gt Select your country gt Data sheet direct
Download Pdf Manuals
Related Search