INSTALLATION '8: OPERATING INSTRUCTIONS
Contents
1. E LIFT UP TURN amp RELEASE Operate actuator from one extreme to the other several times to check switch operation Replace housing cover Confirm that you have noted the final position of the valve full open or full closed Install the Beacon on the AccuTrak cover following the instructions included with the unit Make sure the Beacon visual display coincides with the position of the valve 9 Unit is now ready for automatic operation 10 If any assistance is required please feel free to call Westlock Controls at 01892 516277 FIELD WIRING IF ACCUTRAK IS ALREADY ATTACHED TO A VALVE AND ACTUATOR 1 Note graphic display of the Beacon and circle 4 The proper wiring diagram for your unit is shown one of the coinciding drawings shown below on the inside of the AccuTrak cover Please follow carefully Valve in OPEN position ee a Valve in CLOSED 7 ll position _ aaeeeo ra STANDARD FLOW ARRANGEMENTS PART NO ARRANGEMENT NUMBER 90 ROTATION ral fT 5 Complete the electrical wiring in accordance with relevant Electrical Codes The ground wire should be secure under the green screw Check all screws for tightness If the installation is in a hazardous area all electrical leads must be sealed in accordance with relevant Electrical Codes BM3 3 Always check the nameplate to make sure the I P rating coincides with the application BM3 5 9 BM3 9 WAR2. INSTALLATION amp OPERATING INSTRUCTIONS WESTLOCK ACCUTRAK 2100 2200 3000 amp 3400 SERIES With Mechanical Switches or Hermetically Sealed MAGNUM Proximity Switches or Inductive Type Proximity Sensors IMPORTANT If the AccuTrak is in the field already mounted on an actuator and valve please follow the field wiring instructions on the reverse side INSTALLATION WARNING The AccuTrak should always be handled with care when the cover is removed and wired to an electrical power source 1 Attach the proper mounting bracket and adapter to the AccuTrak housing with the hardware provided Operate the actuator to full closed position Attach the AccuTrak and mounting bracket to the actuator Remove screws in AccuTrak housing twist cover approximately 45 and lift straight up Wiring diagram inside of AccuTrak cover TWIST COVER 45 THEN LIFT STRAIGHT UP 5 To set switches lift bottom cam and turn until switch is activated and then release Spring will push cam back onto the splined shaft Operate the actuator to the opposite extreme push down on the top cam and turn until the open switch is activated MECHANICAL SWITCHES PUSH DOWN TURN amp RELEASE LIFT UP TURN amp RELEASE MAGNUM PROXIMITY SWITCHES MAGNET EMBEDDED IN CAM PUSH DOWN TURN amp RELEASE INDUCTIVE TYPE PROXIMITY SENSORS ACTIVATOR EMBEDDED PUSH DOWN TURN amp RELEAS
3. NING The conduit plugs supplied with the monitors are for transit purposes only cable glands and cabling methods used in service must be suitable for type of protection Any unused cable entry hole must be closed with stopping plug suitable for type of protection or long term storing CAUTION TO PREVENT IGNITION OF HAZARDOUS ATMOSPHERES REPLACE COVER BEFORE ACTUATING THE ELECTRICAL CIRCUITS KEEP COVER TIGHTLY CLOSED WHEN IN OPERATION 6 Replace housing cover and the Beacon Confirm that the Beacon graphic display coincides with the display originally circled in Step 1 2 Remove the Beacon 7 Unit is now ready for automatic operation 3 Remove the screws in the AccuTrak housing twist cover approximately 45 and lift straight 8 If any assistance is required please feel free to up call Westlock Controls at 01892 516277 CONTROLS LIMITED 22 Chapman Way Tel 01892 516277 m Fax 01892 516279 Tunbridge Wells Kent TN2 3EF England
Download Pdf Manuals
Related Search