Hessaire MFC6000 Use and Care Manual
Contents
1. exhausted from the room Constant air change is essential and part of the fresh air benefit from evaporative aircooling Remember your cooler has been designed to operate even if it runs out of water No damage will be caused to the pump if your cooler runs out of N water Cooler Maintenance DISCONNECT FROM THE POWER SOCKET A Disassemble the back panel Unscrew the screws in the Pull out the bottom of the back panel first then pull the back panel then take it back panel up down B Drain the water tank Remove the drain plug lean the cooler and draining the water from the tank Casters Assembly Take out the 4 casters and screws after open the paper package screw them at the bottom of the tanks and move the cooler smoothly Trouble shooting Problem Cause Remedy 1 Cooler fails to work at all 1 1Check that the unit is plugged properly 1 2 Check the POWER switch push it to ON 2 Cooler does not pump 2 1 Pump is not activated Turn the PUMP swtich to ON 2 2 water level is low Fill with water and make sure pump is activated 2 3 Pump may be defective Replace pump 3 Fan does not operate 3 1 Check that unit is plugged properly 3 3 If connected to a GFCI outlet check if it is tripped 4 Louver does not operate 4 1 Louver does not move Louver switch position to ON 3 2 Check the POWER switch push it to ON 5 Water leakage 5 1 Check the cap of the drain assembly make2. sure it tightened NOTICE This product may temporarily produce an Odd Odor when first turned on This is NORMAL and wil dissipate after a few hours
3. READ AND SAVE THESE INSTRUCTIONS MOBILE EVAPORATIVE MFC3600 6000 1 Control panel 2 Top cover tray 3 Back panel 4 Side panel 5 Front grill 6 Vertical louvre 7 Water level indicator 8 Water filler door 9 Water tank 10 Caster 11 Drain assembly To Operate The Cooler A Filling water 1 0pen water filler door 2 Fill cooler with water 3 Watch water level indicator and stop adding water as full graphic enters indicator window If the float valve is assembled in the machine it can connect with water hose directly Safety Rules IN ORDER TO REDUCE THE POSSIBILITY OF FIRES ELECTRIC SHOCK OR PERSONAL INJURY 1 Unit must be in the OFF position and Unplugged from power receptacle when performing any maintenance 2 To reduce the risk of electric shock plug unit into a properly grounded receptacle 3 To reduce the risk of electric shock install only on a circuit protected with a Ground Fault Circuit Interrupter GFCI 4 This appliance is not intended for use by persons including children with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety Children should be supervised to ensure that they do not play with the appliance vI Do not operate any cooler with a damaged cord or plug Discard the cooler or return to an authorized se
4. rvice facility for examination and or repair 6 Do not run cord under carpeting Do not cover cord with throw rugs runners or similar coverings Do not route cord under furniture or appliances Arrange cord away from traffic area and where it will not be tripped over WARNING To reduce the risk of fire or electric shock do not use this fan with any solid state fan speed control device B Connect to power point C Seclecting Cooling Mode O Machenical Control Fan and Cooling Switch O bg du 3 fanand High Low Low cooling Cool Cool Fan power off O Electronic Control o w a O Power Fan Pump Timer Oscillator Location KEY OPERATIONAL POINTS 1 Your cooler must be positioned in front of an open window or door if it is to operate effectively Alwaysl ensure that there is another open window or door through which the air can exhaust from the room 3 Ensure the filter is kept clean throughout the summer season 4 At the end of each day run your cooler on FAN ONLY for 30 minutes to dry out the filter 5 Prior to putting your cooler away for winter always a Drain the tank and wipe out clean b Clean the filter Reassemble and run on FAN ONLY for 30 minutes to dry out the filter LOCATION LOCATION LOCATION Having completed assembly of your cooler position the unit with its back to an open window or door This will allow fresh air to be drawn through the cooler and
Download Pdf Manuals
Related Search