Sea Gull Lighting 94560-71 Installation Guide
Contents
1. INCORRECT CONTACT Q CORRECT CONTACT Q wa lt gt CAP R CONDUCTOR P CONDUCTOR P FIGURE 3 FOR MONO POINT INSTALLATION Fig 2 1 2 Remove rail adapter N by cutting wire below rail adapter N Slide collar E canopy D mounting bar A lockwasher amp hex nut B and nipple C to the top of the splice compartment G Install strain relief O Tighten strain relief set screw with a flat head screwdriver Attach mounting bar A to outlet box using outlet box screws not supplied Make electrical connections a House Black to Fixture Black b House White to Fixture White c House Ground to Green Ground Screw Make sure no wires are left exposed and carefully tuck wires into outlet box Raise canopy D to ceiling and secure in place by threading collar E to nipple C ATTACH PENDANT TO RAIL Fig 3 1 Unthread cap R from rail adapter N 2 Making sure contacts Q will align with conductors P on rail set the bottom of rail adapter N to the bottom of the rail and roll rail adapter N up onto the rail Install fixture to rail by closing hinged side of rail adapter N over rail and threading cap R back onto adapter N tightly SHADE H SOCKET M GLASS ENCLOSURE J FIGURE 42. INSTALLATION AND SAFETY INSTRUCTIONS GROUNDING AND MOUNTING BAR _ LOCK UP FOR OPTIONAL NE omer was CANOPY RAIL ADAPTER N TB Ge OUTLET BOX CONNECTORS l lt SHIPPING N _ R BREAK S GROUND WIRE SHADE H STRAIN RELIEF 0 MOUNTING LOCKWASHER amp HEXNUT B COLLAR E gt J FIGURE 1 NOT INCLUDED FIGURE 2 a NOT INCLUDED IMPORTANT SAFETY INSTRUCTIONS NOTE This pendant can be hung either from a Transitions Series e Be sure the electricity to the system you are working on rau Labeda pana or arom me suppied canopy oem is turned off either the fuse removed or the circuit instructions for the appropriate mounting method breaker set at off e For use with the 120V Transitions track series by Sea Gull Lighting e Caution To reduce the risk of burn during relamping remove from the track before relamping e Use of other manufacturers components will void warranty listing and create a potential safety hazard e lf you are unclear as to how to proceed contact a qualified electrician e Minimum distance from the front of the lamp to combustible surfaces is 8 e Make sure all connections are tight e Dimming halogen lamps greatly reduces lamp life e Lamp gets HOT quickly Contact switch only when turning on e Do not touch hot lens guard or enclosure e Do not touch the lamp at any time Use a soft cloth Oil from skin may damage lamp A M B A N C E gt e Do no
3. t operate the luminaire fitting with a missing or 7 Aceh A See ke damaged shield LIGHTING SYSTEMS e Save these instructions L R 1 0 5 062408 www SeaGullLighting com ASSEMBLING PENDANT SHORTENING PENDANT 1 FIXTURE INSTALLATION LR 105 Determine length of pendant and shorten cable above the splice compartment G Be sure to add 5 for electrical connections when installing as a mono point Unthread top of splice compartment G Set top half of splice compartment G and strain relief collar at desired location NOTE Strain relief collar is threaded and should be threaded up and down cable Be sure 1 4 of cable jacket is protruding out of strain relief collar Secure in place by tightening the set screws Assemble stem l together at shipping break S by holding top half of stem I in place and threading socket half of the stem l To install shade H remove three prongs off of spider V by unthreading Install shade H and replace the three prongs onto spider V so shade H rests evenly on the spider V Make connections between socket leads and pendant cable using wirenuts inside the splice compartment G Black to Black White to White Ground to Ground Make sure no wires are left exposed and carefully tuck wires into bottom half of splice compartment G Close splice compartment G by threading the two halves together Install lamp K Thread glass enclosure J over lamp K
Download Pdf Manuals
Related Search