CANARM RICH104B03CH17 Installation Guide
Contents
1. retea THE ROYAL Monday Through Friday 8 00am 5 00pm E S T Chandelier COLLE CTION Questions or Concerns Contact Canarm At 1 800 265 1833 English or 1 800 567 2513 French SAFETY PRECAUTIONS 1 TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE DO NOT REMOVE INSULATION FROM FIXTURE REQUIRED Phillips Screwdriver Wire Cutters RC 2 03 03 Wiring supplies as required by electrical code Wrench Pliers 2 THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED NOTE Product May Not Look Exactly As Shown In Figures INSTALLATION X Outlet Box Mounting Bracket Upper Connector Canopy Nut L Nipple Upper Connector Ground Wire Black White Nut Canopy 1 o Attach the mounting bracket to the outlet box using electrical box screws and flat washers Attach the nipple to the mounting bracket and adjust until it will clear the canopy when assembled Place the canopy over the nipple and tighten the upper connector onto the nipple until snug The upper connector should hold the canopy snug to the ceiling Lock the nipple in the correct position using the brass nut 2 Spread one end of chain open and fasten to the lower connector Weave the power cord and ground wire through the links in the2. chain Spread the other end of the cord open and fasten to the upper connector 3 Feed the wires through the hole in the upper connector Loosen off the nut on the upper connector and slide it down the chain towards the lower connector Slide the canopy down the chain towards the lower connector Als Feed the wires through the nipple and tighten the upper connector onto the nipple 5 Connect the copper wire to ground screw in electrical box Connect the black wire or wire marked SPT 1 from the fixture to the black wire in the electrical box and connect the white wire from the fixture to the white wire in the electrical box 6 Tuck electrical wires into electrical box Slide canopy into position and tighten in place by sliding upper connector nut into position and tighten Note If required hook the support arms onto fixture and then into the glass or hoop Note If required assemble centre body of fixture Note If your product does not have any uplights please proceed to Step 8 Note If required soread the arms of the fixture out evenly STYLE 1A Bulb 2 Shade 7 Tube STYLE 1B _ Finial amp Shade STYLE 2 lt Spinner Nut Glass Fixture socket WY STYLE 3 Glass Hole For Stem Washer Hex Nut Decorative Ca La Finial Za Note Refer to the style of assembly that matches the style of your fixture If your fixture ha
3. s shades STYLE 1A Place shade on tube then install bulb STYLE 1B Install bulb shade then finial STYLE 2 Remove spinner nut from socket Position glass on lamp and secure with spinner nut Note Glass may face up or down Note If your fixture has candle style lights slide the tubes over the uplight sockets STYLE 3 Install proper bulb type and wattage before assembling the glass Remove ball screw from the curved stem Position glass on lamp with the curved stem being inserted through the hole in the glass Hand tighten the ball screw to secure the glass in place 8 If not already done install proper bulb type and wattage Note If your product does not have a bottom light your fixture is complete 9 Attach the stem to the fixture 1 0 Position the glass over the stem Secure the glass in place using the fibre washer hex nut decorative cap and finial Imported By CANARM LTD 2157 Parkedale Ave Brockville Ontario K6V 5V6 Tel 613 342 5424 Fax 613 342 8437
Download Pdf Manuals
Related Search