none FG0007BA Instructions / Assembly
Contents
1. dry hot climates water evaporates very quickly so it may be necessary to check the water level every day The rate of water evaporation will also be greater with larger fountains with more surface area than smaller fountains MAINTAINING THE FOUNTAIN Keep the fountain water and pump clean and clear of debris If placed under a tree or near vegetation you may need to scoop out leaves and other debris every other day Water treatments that prevent algae growth and mineral deposits are available at your local home amp garden stores If the fountain is not in use for an extended period of time disconnect the power and empty all the water from the fountain Do not tip the fountain to empty the water Use a siphon pump or a small bucket The fountain should not be operated in temperatures below 41 F 5 C to prevent frost damage During winter months before the temperature hits freezing disconnect the power drain your fountain and store it in a heated area If the fountain is stored outdoors in freezing temperatures disconnect the power empty all the water from the fountain remove the pump and any lights if possible make sure it is completely dry and cover it with a tarp Any water left in the fountain may freeze and expand causing the fountain to crack Care and Maintenance continued Preventing Mosquitos If mosquitoes are a problem in your area it is recommended to run the f2. obligation and buyers only remedy shall be for the manufacturer to either replace and or repair at the manufacturers sole discretion the product as described above Neither seller nor the manufacturer shall be liable for any injury loss or damages for lost profits lost sales injury to person or property or any other incidental or consequential loss arising from any cause whatsoever no matter whether based upon warranty contract negligence or other misuse and the buyer and user agree that no other remedy shall be available to them Before using the buyer and user shall determine the suitability of the product for the intended use and assume all risk and liability whatsoever in connection therewith The warranty and remedy described in this limited warranty is an exclusive warranty and remedy in lieu of any other warranty or remedy expressed or implied All other warranties and remedies are hereby expressly excluded including but not limited to any implied warranty of merchantability of fitness for any particular purpose OTHER LEGAL RIGHTS This warranty gives the buyer and user specific legal rights and buyer and user may also have other rights which vary from state to state Some states do not allow exclusions or limitation of incidental or consequential damages so the above limitations or exclusions may not apply to you Contact the Customer Service Team at 855 HD HAMPTON or visit www Hamptonbay com 3 HAMPTONBAY COM Please contact 1 85
3. 5 HD HAMPTON for further assistance Pre Assembly PLANNING ASSEMBLY Unpack all parts from the packaging and ensure there are no missing or damaged parts If any parts are missing or damaged do not attempt to assemble or use the product Contact the Customer Service Team at 1 855 HD HAMPTON or visit www Hamptonbay com PACKAGE CONTENTS Part Description Quantity A Pump Part No PT 300 70 1 B Planter 1 C Pump cover 1 D Fountain body 1 E Base 1 Assembly 1 Assembling the fountain body Select a flat level surface for the fountain location Place the base E onto the ground and ensure that it is level Position the fountain body D over the base E and twist clockwise until the parts are secured together Attaching the pump Lead the water supply tube 1 located under the planter B through the hole in the pump cover C Place the planter B on top of the pump cover C Put the pump A into the bottom of the fountain body D horizontally and draw out the pump power cord from the edge of the fountain body D and keep it in the groove Place the pump cover C and planter B over the pump A Add clean water into the fountain body D The required water volume is 7 liters 1 85 gallons or just a little lower than the pump cover level Place a real or decorative plant not
4. Item 1000 020 108 Model FG0007BA USE AND CARE GUIDE TWO TIER VERTICAL RIB PLANTER FOUNTAIN Questions problems missing parts Before returning to the store call Hampton Bay Customer Service 8 a m 6 p m EST Monday Friday 1 855 HD HAMPTON HAMPTONBAY COM THANK YOU We appreciate the trust and confidence you have placed in Hampton Bay through the purchase of this planter fountain We strive to continually create quality products designed to enhance your home Visit us online to see our full line of products available for your home improvement needs Thank you for choosing Hampton Bay Table of Contents S Table of Contents Table of Content 22 ccccccecnsacsecnceceesccnssascnnceceeeesaseacen 2 Safety Information ecce eere 2 Warranty 3 Pre Assembly enini nain d den ane dax ena E nd anna den gn udi RUE 4 Planning Assembly esee rennen nnne Package Contents ttti eniin et lu 5 OPO ALO MD eU n 6 Safety Information Care and Maintenance eene nnn nana nna 6 Water Maintenance eeereerennnnnnnnnn nnns Maintaining the fountain eere Cleaning the Fountain esee rennen Maintaining the pump eren rne nnnnnnnnns Cleaning t
5. he Pump eeeereere nennen nennen Troubleshooting c ceeceec eren r cete eaerenunariciee 8 gt WARNING Risk of electric shock This pump is supplied with a grounding conductor and grounding type attachment plug To reduce the risk of electric shock be certain that it is connected only to a properly grounded grounding type receptacle CAUTION Do not use the pump for industrial purposes WARNING To reduce the risk of electric shock use only on portable self contained fountains no larger than 5 ft 1 52 m in any dimension CAUTION Do not use the pump in vehicles or on board ships or aircraft or in swimming pools WARNING If equipped with a 3 prong grounded type plug do not remove the grounding pin from the plug on the power cord CAUTION Do not use the pump in locations where special conditions prevail such as the presence of a corrosive or explosive atmosphere dust vapor or gas CAUTION Do not lift the pump by its power cord CAUTION Risk of electric shock Do not remove the cord and strain relief Do not connect the conduit to the pump CAUTION The pump has been evaluated for use with water only CAUTION Do not let the pump run dry Pump must be completely submerged for proper operation and cooling CAUTION Before connecting to the power source make sure that the pump is assembled and completely subme
6. included in the planter B according to personal preference HAMPTONBAY COM Please contact 1 855 HD HAMPTON for further assistance Operation 1 Turning the pump on Connect the pump power cord to a GFCI outlet Water begins to flow through the fountain NOTE To eliminate the possibility of water damage around your fountain check for leaks and excessive splashing after the initial setup of your fountain If the water flow from the m basins is uneven then check to see if the fountain is level It is highly recommended this fountain be placed in an area where it cannot be damaged should the area become wet and unstable periods of time when no one is present to observe the j NOTE Do not leave your fountain running for extended performance and water level Care and Maintenance WATER MAINTENANCE It is recommended that you fill your fountain with distilled water Distilled water is pure and should have no minerals or sediment in it It will extend the life of the pump and the time between cleanings If distilled water is not an option use filtered water as water directly from your tap will generally have minerals and chemicals that can build up and leave behind residue on your fountain Check the water level regularly to ensure the pump is completely submerged during operation This is necessary ensure proper cooling of the pump and prevent overheating In summer months or
7. ountain as much as possible to prevent standing water where mosquitoes breed You may also add a few drops of anti mosquito water treatment available at your local home and garden store to the fountain water Preventing Water Damage To eliminate water damage to floors and or surrounding fountain areas check for leaks and excessive splashing after initial installation and on a regular basis Repairing Leaks If your fountain develops a leak and a visible crack is detected seal the crack with plastic epoxy or Clear Silicone II sealant If the fountain leaks without a visible crack turn the pump off fill the fountain and let the fountain sit for one week If there is a crack it will appear white Remember to keep the water 34 full as water evaporates over time CLEANING THE FOUNTAIN Do not use bleach as it may be harmful to pets and wildlife and may also damage the finish of the fountain Clean the fountain monthly to prevent mineral deposits and contamination which may clog the pump Disconnect the pump from the power source and empty the water from the fountain Use any gentle household cleanser and a soft brush or cloth to clean the fountain Avoid using any harsh chemicals abrasives or rough scrubbing as this could damage the finish on your fountain The frequency of cleaning may vary depending on the location of your fountain MAINTAINING THE PUMP Use a pre filter on your pum
8. p if available to prevent it from clogging with leaves or other debris Regular cleaning of the pump is necessary depending upon the environment in which it is operated Clean the pump when it is visibly soiled or when a noticeable decrease in performance is detected Failure to clean the pump will result in overheating of the pump Although it is not required pumps generally last longer if left running continuously as it reduces the wear from starting and stopping CLEANING THE PUMP WARNING Before cleaning always disconnect the pump from the power source Disassemble the pump by removing the regulator 1 front cover 2 and impeller plate 3 Remove the impeller rotor assembly 4 by gently pulling on the impeller blades Use a soft cloth or brush to clean the area inside of the pump housing 5 Clean the front cover 2 regulator 1 and impeller assembly 4 in warm soapy water Reassemble the pump and inspect for proper operation 7 HAMPTONBAY COM Please contact 1 855 HD HAMPTON for further assistance Troubleshooting Problem Solution The pump does not operate Check to make sure the pump is connected to a power source Check the water level to ensure the pump is completely submerged Add water as needed The pump operates but there is no water flow Check the water level to ensure the pump is completely submerged Add wate
9. r as needed Check the supply tube for any kinks or folds and correct The pump operates but there is no water flow and the pump is fully submerged and the supply tubing has no kinks Disconnect the pump from the power source Disconnect the supply tube from the pump outlet Check for clogs or holes and clean the tubing inside and outside if necessary Check for clogs and clean the pump inlets and outlet if necessary Place the pump back into the water outlet side up and then re connect the pump to the power source Once the water begins to flow from the pump re connect the supply tubing to the pump outlet Check for any air trapped in the water supply tube which may prevent the pump from working The pump runs with low or high water circulation Check and adjust the regulator dial or slide on the front of the pump Adjust the dial slide towards to increase water flow or towards to decrease water flow The pump operates but the water flow is uneven or non existent and the pump makes noise The pump starts to make noise Check the impeller assembly for wear Remove the front cover and regulator impeller plate and remove the impeller assembly Clean the impeller assembly and inspect for wear If the rotor spins freely from the magnetic body the impeller assembly is worn and needs to be replaced Contact customer service for replacement pa
10. rged in water CAUTION Keep the plug dry Do not expose the plug to water or steam CAUTION Always disconnect the pump from the power source before performing any maintenance on the pump lights if equipped or fountain CAUTION Do not use the pump in water exceeding 86 F 30 C CAUTION Do not exceed the voltage shown on the pump ree ee gt gt CAUTION Do not use the pump with flammable liquids Al All All All eal dll lel CAUTION Check the water level regularly to ensure the pump is completely submerged during operation Do not add water while operating the product Always disconnect the pump from the power source before adding water Warranty LIMITED WARRANTY This product is warranted to the user against missing parts defective material and workmanship under normal working conditions for a period not to exceed the term noted on the chart below This warranty period begins on the date of purchase by the original purchaser Fiber Clay Product 90 days on construction materials paint and finish Pump 90 days This warranty covers only properly installed and maintained units Pump warranty is limited to applications pumping fresh water at temperatures between 41 F 95 F 5 C 35 C with a PH range of 5 9 Upon receipt of a defective item the manufacturer will at its sole option repair replace or refund as appropriate an
11. rts Check the water level to ensure the pump is completely submerged If the water level drops below the pump intake it may suck in air and cause the noise or the pump to completely stop working Move the pump away from the sides of the basin or place a piece of foam or sponge underneath the pump to isolate any vibration which causes the noise The water starts to foam Check the water level to ensure the pump is completely submerged If the water level drops below the pump intake it may suck in air and cause the pump to spit and foam the water Add a few drops of anti foaming water treatment available at your local home and garden store to the fountain water The water flow is uneven Gently sweep across the water surface to achieve even water flow across the face of the fountain Check the top of the basin to ensure it is level If not shim the basin from the bottom until the top spillway is level or has achieved even water flow all around Questions problems missing parts Before returning to the store call Hampton Bay Customer Service 8 a m 6 p m EST Monday Friday 1 855 HD HAMPTON HAMPTONBAY COM Retain this manual for future use
12. y defective parts free of charge and return it to you postpaid If it is appropriate to replace your product the manufacturer will replace the product with the same product or a comparable product at the manufacturer s option GENERAL TERMS AND CONDITIONS Proof of purchase is necessary to request a claim under this warranty This warranty does not apply to appearance or accessory items This warranty does not include damage due to improper packing handling or transportation For products lost or damaged in transit a claim should be filed with the carrier This warranty does not cover any costs associated with the installation and removal of products or parts subject to this warranty This warranty shall not apply to acts of God nor shall it apply to products which have been subject to negligence abuse accident misapplication tampering alteration or modification nor due to improper installation operation maintenance repair or storage nor to other than normal application use or service including but not limited to operational failures caused by corrosion rust or other foreign materials in the system or operation at pressures in excess of recommended maximums DISCLAIMER Any oral statements made about the product by the seller the manufacturer the representatives or any other parties do not constitute warranties should not be relied upon by the user and are not part of the contract for sale The sellers and manufacturers only
Download Pdf Manuals
Related Search