Husky C801H Installation Guide
Contents
1. Check oil level in pump See Oil paragraph in the Maintenance a section for instructions 3 Recheck all wiring Make sure wires 9 are secure at all terminals connections Make sure all contacts move freely and are mot obstructed FIGURE 3 DD not supplied Line up holes in surface with holes in air compressor feet J Place the washers AA supplied between the floor and air compressor feet see figure lf needed use shims DD to level the unit Place the 3 8 lag screws CC through the air compressor feet J washers AA and into the anchors BB Torque 4 87 lag screws to 7 10 ft lbs 9 5 13 5 Nm cc Pa not supplied Surface Line BB not supplied Move the Autot switch A to Auto Run the air compressor for 20 minutes Make sure the drain valve and all air lines are open so there is only a minimal air pressure build up in tank Check all air line fittings and connections piping for air leaks sli a soap Check for excessive vibration Readjust or shim air compressor feet if necessary After 20 minutes close the drain valve The air receiver will fill to cut out pressure and the motor will stop The air compressor is now ready for use 4 Open the drain valve F fully to permit air thes escape and prevent air pressure2. Assembly Location of the air compressor 1 Locate the air compressor in a clean dry and well ventilated area 2 Located the air compressor at least 18 in 0 5 m away from the wall or other obstructions that will interfer with the flow of air 3 Locate the air compressor as Close to the main power supply as possible to avoid using long lengths of electrical wiring NOTE Long lengths of electrical wiring could cause power loss to the motor 4 The air filter must be kept clear of obstructions which could reduce air flow to the air compressor Assembly continued Anchoring of the air 4 compressor Figure 3 WARNING Risk of bursting 6 The air compressor MUST be bolted to a level 7 solid concrete surface Use 3 8 lag screws washers supplied and concrete anchors lf help is needed anchoring the air compressor consult a licensed contractor 1 Place the air compressor on a level solid concrete surface Make sure the concrete is in good condition with no oacks or damage 2 Mark the surface using the holes in the air compressor feet J as a template 3 Drill holes in the surface for the concrete anchors Install concrete anchors HB 3 Breaking in the pump a 6 I This procedure is required before the air compressor is put into service and when the check valve or a complete compressor pump has been replaced 1 Make sure the Auto Of switch A is in the Off position 2
Download Pdf Manuals
Related Search