Speakman SEF-1850-TW Installation Guide
Contents
1. Instructions for Adding Tepid Water Eyewash Option to Models SEF 1 850 SEF 1 850 8 Need Help For additional assistance or service call SPEAKMAN Company 400 Anchor Mill Road New Castle DE 19720 PHONE 800 537 2107 EMAIL customerservice speakmancompany com WEB www speakmancompany com 92 SEF 1850 TW R 1 What You Need To Know Tools Required Crescent Wrench Helpful Flat Head Screwdriver Important Notes The supply line for the eyewash shall provide an uninterruptible supply of flushing fluid at a minimum of 30 psi flowing pressure If shut off valves are installed in the supply line of the eyewash provisions shall be made to prevent unauthorized shut off ANSI Z358 1 requires that all emergency equipment shall be tested weekly to verify proper operation and inspected annually to assure conformance with ANSI Z358 1 requirements Be sure to read instructions thoroughly before beginning installation Do not overtighten any connections or damage may occur Safety Tips Cover your drain to prevent loss of parts Always wear eye protection Maintenance Keep the EYESAVER faucet looking new by cleaning it periodically with a soft cloth Avoid abrasive cleaners steel wool and harsh chemicals as these will dull the finish and void your warranty oO Start off by following steps 1 through 3 of the SEF 1850 installation instructions Next prepare the SE 370 for mouniting A2. blue COLD hose SE 85 O TW ROUGEH N DIAG RAM coming from the SEF 1850 24 MIN 36 MAX COUNTERTOP HEIGHT 18 MAX EYEWASH HOSE The eyewash hose also pre installed in the body of the SEF 1850 can now be connected to the outlet port on the SE 370 Wrench tighten At this point turn on the water supply and check for leaks If the tepid water temperature needs adjustment refer to the SE 370 instruction manual HOT HOSE COLD HOSE JC EYEWASH HOT SUPPLY A d e COLD SUPPLY 6 LONG os NOTE DRAWING IS NOT TO SCALE BE SURE TO KEEP THE SE 370 AS CLOSE TO THE CENTER OF THE FAUCET BODY AS POSSIBLE
3. fter applying Teflon tape to the larger 1 2 threads screw the adapters into the 3 ports of the SE 370 Wrench tighten Refer to the rough in diagram on the last page during installation The SE 370 can now be mounted to the wall The unit should be fastened to the wall using 1 2 pipe hangers with wall plates not included no more than 18 below the countertop Be sure to mount the SE 370 in a location that will not interfere with the drain assembly or wall stops Retrieve the two 6 long stainless steel hoses from the box Connect 5 Locate the remaining two stainless steel hoses Connect one hose to one to the COLD supply valve and the other to the HOT supply the E port of the HOT supply tee Connect the other hose to the E valve Wrench tighten both connections Locate the two tees The free end of the 6 hoses will connect to the unmarked port of each tee Wrench tighten both connections The free ends of these hoses can now be connected to the respective HOT and COLD inlet connections of the SE 370 Wrench tighten both connections Cy 1C 7 Connect the red HOT hose from the SEF 1850 to the F port on the HOT supply tee Repeat this process for the
Download Pdf Manuals
Related Search