Universal Hardware UH40042 Instructions / Assembly
Contents
1. rose mounting plate 1B Turn outside rose to adjust center line of lock body to match the centerline of the door CHANGING DIRECTION OF KEYWAY Keyway direction is normally in down position To change the direction follow steps below for more details see reverse page X A Turn key 75 clockwise insert push pin into catch hole to depress knob catch Pull outside knob off of spindle B Turn knob 180 and then reinstall knob After door is closed deadlocking plunger is retracted CENTER LINE 2015 Hampton Products International Corp 50 Icon Foothill Ranch CA 92610 3000 USA www universalhardware com 1 877 701 7837 999 00400_REVA 08 152. UNIVERSAL HARDWARE The Professional s Choice LOCK BODY MOUNTING PLATE MOUNTING INSIDE SCREWS ROSE A INSIDE SLEEVE FOR 1 HOLE INSIDE KNOB COVER NEW DOOR PREPARATION 1 Fold template on edge of door and mark holes 2 Drill a 2 1 8 hole through face of door NOTCH from both sides to 9 32 Woe i i 5 3 avoid damaging door 2 HIGH va DEep 3 Drill a 1 hole in edge RECOMMENDED of door 4 Cut 5 32 notches on HEIGHT 38 FROM FLOOR 2 1 8 hole on both BACKSET MORTISE sides of door 5 Mortise door edge 2 1 4 x 1 1 8 x 1 8 2A Install latch and secure with screws provided 2B Slide lock body into door and make sure that latch prongs engage lock body INSTALL INSIDE KNOB MOUNTING 3A Install mounting plate and secure with mounting screws LOCK BODY 3B Screw inside rose onto spindle until hand tight 3C Push inside knob all the way onto spindle until it clicks into catch hole INSIDE KNOB INSIDE ROSE LATCH S9 Y INSTALLATION INSTRUCTIONS FOR CYLINDRICAL KNOBSET MODELS UH40041 UH40042 amp UH40043 999 00400 OUTSIDE OUTSIDE KNOB COVER OUTSIDE KNOB ASSEMBLY PUSH PIN S RETAINER COMBINATION qa SCREWS A TOOLS REQUIRED PUSH PIN PROVIDED NO 2 PHILLIPS HEAD SCREWDRIVER 1 8 INCH DRILL BIT INSIDE ROSE INSIDE KNOB 2 N Q 2 PUSH PIN 1A Use push pin to depress knob catch and pull off inside knob then remove inside
Download Pdf Manuals
Related Search