Rockwell RK9033 Use and Care Manual
Contents
1. ATION Make sure the legs are fully opened and that both the height clamp and the bevel locking knob are fully tightened before applying heavy loads e Do not overload Max load per JAWSTAND 220ib 100kg e Do not stand on this product 1 ADJUST SUPPORT HEIGHT The scales on the column indicate the slide height above the ground To adjust the height loosen the height locking knob and move the head upward or downward Read the scale from the top edge of the base See Fig E1 amp E2 2 CLAMPING Rotate the clamp knob the moving clamp 13 will move forward or backward for clamping or loosening work piece against the fixed pads 14 See Fig F e When clamping materials less than 3 4 thick use a packing piece See Fig G e When hanging doors Rotate the bevel bracket from Odeg to 90deg Tighten the clamp knob to clamp the door side and put a spacer block under the door to support the hinge line 3 SUPPORTING 1 Clamp an extension piece ie An offcut of sheet material as shown on product carton into the head channel if using JAWSTAND to support material at a height greater than its maximum adjustment See Fig 2 The JAWSTAND as a support accessory can help to support long or large work pieces See Fig J1 amp J2 Adjust the support table height to level with work table of miter saw table saw thicknesser etc For very large work two jawstands and a length of 2x4 can provide extra long travel support e2. Make sure the JAWSTAND is securely pegged down to the ground when applying non vertical loads or when on sloping ground See Fig K 4 LEVEL SUPPORT SEE FIG L A bubble level is recessed in the slide on top of JAWSTAND 5 STORAGE Folding is the reverse procedure of above step 2 in assembly In this stored position you can save more space in your workroom as shown in Fig M
3. PORTABLE WORK SUPPORT TECHNICAL DATA Maximum clamp width 1 3 4 Max load 220 ibs Height adjustment range 29 41 Bevel adjustment range 0 90 Folded minimum length 43 Weight 13 2 Ibs OPERATING INSTRUCTIONS KANTE Before using the JAWSTAND read this instruction book carefully ASSEMBLY 1 UNPACKING This product requires some assembly Carefuliy remove the JAWSTAND from the box The head and the column of the tool are separated from the tripod base See Fig A1 First loosen the height locking knob 9 Then insert the column of the tool into the base and tighten the knob See Fig A2 Inspect carefully to make sure no damage occurred during shipping Do not discard the packing material until you have carefully inspected and satisfactorily operated the tool 2 SET UP INSTRUCTIONS 1 Unfold the tripod legs of the main body and extend the column upwards to the desired height there is a limit stop See Fig B1 amp B2 NOTE The legs should pivot smoothly but firmly Adjust the nuts on the leg pivot bolts a if necessary See Fig B3 2 Loosen the bevel looking knob and rotate the beveling head until the slides are horizontal then tighten the knob as shown in Fig C1 amp C2 Make sure the head locks firmly Adjust the nut tension on the pivot bolt b if necessary See Fig D The head should pivot firmly and should lock tightly at any selected angle when the bevel locking knob is tightened ADJUSTMENT AND OPER
Download Pdf Manuals
Related Search