VIAIR 91025 Use and Care Manual
Contents
1. R EACH USE FAILURE TO DRAIN TANK AND REMOVE CONDENSATION WILL CAUSE TANK TO RUST PREMATURELY a To remove any accumulated condensation inside the tank bleed pressure from tank until pressure is approximately 5psi to 20 psi b Drain water from tank by opening the drain cock drain valve c If drain cock valve is plugged release all air pressure from tank remove drain valve and clean then reinstall d After water has been drained close the drain cock IMPORTANT Please observe air tank s Date of Manufacture stamped on tank leg Replace air tank 2 to 5 years from date air tank was first used or use the date of manufacture as reference Your adherence to air tank draining guidelines will determine the replacement date of your air tank RUSTED TANKS CAN FAIL CAUSING EXPLOSIONS OR FATAL INJURIES Discard tank immediately if tank is rusted NOTE When using a safety pressure relief valve point the safety pressure relief valve away from your body when releasing air Use the pull ring on the safety relief valve open the relief valve to vent any pressure inside the tank before attempting to service tank USER MANUAL 3 D A J IVLVIGN DED LAN Ni Safety Valve 2 5 Gallon Air Tank Drain Cock FOR 2 5 GA TANK OWNERS We have included 6 pcs of rubber bushings in your tank mounting hardware You have the option of using two layers of rubber bushings on one of your tank lags to slightly tilt tank toward dra2. VIAIR Your Vital Air Source PART NO 91025 It is essential that you and any other operator of this product read and understand contents of this manual before installing and using this product Your air tank comes with six 4 NPT port openings to allow installation in many positions on your vehicle To insure safe and trouble free use of your air tank we strongly recommend that you install a drain cock and a safety pressure relief valve on your air tank We recommend use of our Tank Port Fittings Kit Part No 90005 which comes with a drain cock a 175psi safety valve and three plugs IMPORTANT a Tank is rated for 150 PSI maximum working pressure Do not overfill Overfilling may result in death or serious injury b Tank is not to be used as a breathing device Always wear ANSI approved safety glasses when operating air tank Bleed pressure from tank after each use and before servicing or adding attachments e Use only attachments or tools rated for 150 PSI working pressure or less a 9 CAUTION DO NOT PRESSURIZE YOUR TANK UNTIL YOU HAVE INTALLED ALL NECESSARY PORT FITTINGS AND ACCESSORIES a Apply sealant to threads of fittings prior to assembly and tighten each part with a wrench b Do not over tighten if your port fittings are made from brass since brass threads can be stripped The fittings need to be only air tight c Always release air from tank before servicing or repairs WARNING DRAIN TANK AFTE
3. in hole to improve drainage when using a drain cock TROUBLESHOOTING CHART PROBLEM POSSIBLE CAUSE S CORRECTION Locate leak by applying soap amp Tank loses air Air leaks from fittings water solution Tighten as needed pressure Replace tank immediately Pinhole from internal rusting of tank pressure must exceed Can t get air Low tank pressure pressure increase tank pressure from tank LIMITED WARRANTY VIAIR Corporation warrants this product when properly installed and under normal conditions of use to be free from defects in workmanship and materials for a period of one year from its original date of purchase To receive warranty service or repair please contact VIAIR Corporation Returns should be made within one year of the date of purchase after a Return Goods Authorization RGA number has been assigned by VIAIR Corporation To obtain RGA fax a copy of your receipt to 949 585 0188 For complete warranty details please visit www viaircorp com warranty Your Vital Air Source VIAIR CORPORATION 15 EDELMAN IRVINE CA 92618 TEL 949 585 0011 FAX 949 585 0188 Wwww viaircorp com
Download Pdf Manuals
Related Search