Speakman SB-1011 Installation Guide
Contents
1. not overtighten Remove flange 1 and rubber washer 2 from pop up drain assembly Add Teflon Tape 1 to the drain body 2 Apply the provided gasket or plumber s putty to the underside of the flange 3 Insert the threaded end of the drain body up through the drain hole and attach flange to the body with the pivot 4 pointing to the rear of the sink Unscrew the nut 1 from the pop up body Note retain the seal 2 on the horizontal rod 3 Place the nut onto the horizontal rod and insert the rod and seal 2 into the pivot hole 4 Install stopper 5 as non removable 6 Slide nut 1 on and hand tighten only Tighten nut 1 clockwise until the pop up drain assembly is secure Place one end of spring clip 1 on the end of horizontal rod 2 Insert rod through hole in lift rod strap 3 Secure with spring clip 1 Insert lift rod 1 into strap 2 and tighten screw 3 IMPORTANT 9 After installation is completed remove aerator Turn on water supply and allow both hot and cold water to run for at least one minute each While water is running check for leaks Replace aerator 11 01 279 60mm 4 00 101 6mm 3 31 84 00mm MAX 1 51 38 40mm RPG04 0397 PC BN PN 2 RPGO5 0889 HOT VALVE 3 RPGO5 0890 COLD VALVE 4 RPG45 0045 5 RPGO5 0895 PC BN PN 6 RPG24 0127 PC BN PN a 6 08 1542. 40mm 4 3 109 20mm lL 6 07 154 10mm 7 14 181 30mm 2 16 54 80mm qm
3. Instructions for Models SB 101 1 SB 1011 BN SB 1011 PN Need Help For additional assistance or service call SPEAKMAN Company 400 Anchor Mill Road New Castle DE 19720 PHONE 800 537 2107 EMAIL customerservice speakmancompany com WEB www speakmancompany com 92 3333 R What You Need To Know Tools Required rench Pliers Screwdriver Bey alten Groove Joint Phillips Teflon Tape Helpful Supply Lines Basin Wrench ey 2 Utility Knife What You Need To Know Important Notes Be sure to read instructions thoroughly before beginning installation Do not overtighten any connections or damage may occur This faucet has an operating range of 20 80 psi Safety Tips Cover your drain to prevent loss of parts Be sure to wear eye protection while cutting pipe Maintenance Your new Lavatory Faucet is designed for years of trouble free performance Keep it looking new by cleaning it periodically with a soft cloth Avoid abrasive cleaners steel wool and harsh chemicals as these will dull the finish and void your warranty Shut off water supplies Remove old faucet Place gasket 1 on bottom of new faucet Place faucet through mounting holes in sink Secure faucet to sink using mounting nuts 2 provided Make connections to water lines Use 1 2 IPS faucet connections 1 or use the supplied coupling nuts 3 with 3 8 O D ball nose risers 2 Use wrenches to tighten connections Do
Download Pdf Manuals
Related Search