Illumine CLI-EMM030871 Installation Guide
Contents
1. How to Hang Your Ceiling Fan 4 WARNING Turning off wall switch is not sufficient To avoid possible electrical shock be sure electricity Is turned off at the main fuse box before wiring All wiring must be in accordance with National and Local codes and the celling fan must be properly grounded as a precaution against possible electrical shock CEILING amp CAUTION To reduce the risk of electrical shock AT ie disconnect the electrical supply circuit before installing the fan light kit or receiver 4 WARNING The fan must be hung with at least 7 of clearance from floor to blades Figure 13 4 WARNING The outlet box and joist must be securely mounted and capable of supporting at least 50 Ibs Use only a ULL outlet box listed as Acceptable for Fan Support of 15 9kg 35 Ibs or less TWO SCREWS SUPPLIED WITH A WARNING OUTLET BOX HANGER To reduce the risk of fire electric shock or personal Tag BRACKET injury mount fan to outiet box marked Acceptable for Fan Support of 15 9kg 35 Ibs or less and use screws supplled with outlet box Most outlet boxes commonly used for support of light fixtures are not acceptable for fan support and may need to be Figure 14 replaced Consult a qualified electrician if in doubt 1 Securely attach the hanger bracket to the outlet box using the two screws supplied with the outlet box Figure 14 NOTE CEILING COVER SUPPLY WIRES AND FAN WIRES O2. MITTED FOR CLARITY 4 WARNING Hanger bracket must seat firmly against outlet box If the outlet box is recessed remove wall board until bracket contacts box If bracket and or outlet box are not securely attached the fan could wobble or fall Hano 2 Carefully tift the fan and seat the hanger ball katei ia downrod assembly on the hanger bracket that was ye ASSEMBLY just attached to the outlet box Figure 15 Be sure the groove in the ball is lined up with tab on the Figure 15 hanger bracket Figure 14 4 amp WARNING l A WARNING Failure to seat tab in groove could cause damage to To avoid possible fire or shock do not pinch wires electrical wires and possible shock or fire hazard between the hanger ball downrod assembly and hanger bracket How to Wire Your Ceiling Fan If you feel that you do not have enough electrical wiring knowledge or experience have your fan installed by a licensed electriclan 1 Connect the green grounding lead from the hanger ball and the green grounding lead from the hanger bracket to the grounding conductor of supply this may be a bare wire or wire with green colored insulation Securely connect wires with wire connectors supplied Figure 16 4 WARNING To avoid possible electrical shock be sure electricity Is turned off at the main fuse box before wiring NOTE If you are not sure if the outlet box Is grounded contact a licensed electrician for advice as it must be grou
3. ettings while the fan control Is In operation l 6 32 x 3 4 SCREW 2 could damage the control FACEPLATE Set the fan on its HIGH speed pull chain setting Then 6 82 x 1 4 SCREW 2 use your speed contro to select any of the Figure 21 4 speeds plus OFF NOTE The 0 position Is OFF The four fan speeds are selected by sliding the bar to the other four speed positions 1 2 3 and 4 IMPORTANT Always have the fan switch set to HIGH speed before using the wall control To avoid accidental pull chain use shorten chain by cutting It 1 below switch body The SW46 speed control turns all Emerson Ceiling Fans into four speed fans Using Your Ceiling Fan 1 Restore electrical power to the outlet box by turning the electricity on at the main fuse box P REVERSING Era SWITCH 2 All fans are shipped from the factory with the reversing switch positioned to the left circulate air downward If airflow is desired in opposite direction turn your fan OFF and wait for the blades to stop turning then slide the reversing switch to the right position and turn fan on again Figure 22 4 The fan blades will turn in the opposite direction and reverse the airflow Reverse Switch Information Season Rotation Direction Switch Position Figure 22 Summer Counter Clockwise Left Winter Clockwise Right
4. igure 17 Tighten the knurled knobs securely until the ceiling cover fits snugly against the ceiling and the hole in the ceiling cover is clear of the downrod Your fan is new wired to be turned on and off from the fan switch 4 WARNING To avoid possible fire or shock make sure that the operate fan until blades are in place Noise and fan damage could result electrical wlres are completely inside the outlet box and not pinched between the ceiling cover and the ceiling 3 Screw the two threaded studs supplied into the tapped holes in the hanger bracket 4 Lift the ceiling cover up to the threaded studs and turn until studs protrude through the holes in the ceiling cover Figure 17 Wall Control installation 4 WARNING Turning off wall switch Is not sufficient To avoid possible electrical shock be sure electricity is turned off at the maln fuse box before wiring All wiring must be In accordance with National and Local codes and the ceiling fan must be properly grounded as a precaution against possible electrical shock CAUTION To reduce the risk of electrical shock disconnect the electrical supply circult before installing the fan light kit or recelver This control is designed to operate only one ceiling fan Figure 18 This SW46 speed control is rated for 1 2 amps at 120 volts 1 Before disconnecting power ensure that the fan is set at the highest speed NOTE Electric connections should be
5. in accordance with the Natlonal Electrical Codes and all Local Codes Before starting disconnect power to the circuit at the fuse box or circult breaker panel 2 Remove the faceplate and screws from the existing wall switch Pull switch out from wali outlet box 3 Disconnect wire from existing fan wall switch Figure 19 4 Slide the SW46 speed control in the OFF position 0 5 Connect one BLACK wire from the SW46 speed control to the fan motor lead with a wire connector provided Figure 20 6 Connect the other BLACK wire from the SW46 speed control to the 120VAC hot wire with a wire connector provided NOTE Use wire connectors supplied to secure electrical connections 7 Attach the SW46 speed control to the wall outiet box with two 6 32 x 3 4 screws provided Figura 18 WALL OUTLET SWITCH BOX Figure 19 TO NEUTRAL TO FAN MOTOR LOAD MOTOR LOAD 1 2 AMP MAXIMUM Figure 20 8 Position the faceplate provided onto the SW46 speed control Using the two 6 32 x 1 4 screws SW46 SPEED CONTROL screw the faceplate and speed control to the wall outlet box Figure 21 OUTLET BOX 9 Restore power at the main fuse box or circuit breaker panel CAUTION For fans equipped with bullt in variable speed devices These devices must be set at their MAXIMUM SPEED for proper operation Adjustments to their setting must only be made wlth Quietslide in the OFF position Changing or sliding these s
6. nded for safe operation A WARNING This product is designed to use only those parts supplied with thls product and or any accessories designated specifically for use with this product by Emerson Electric Co Substitution of parts or accessories not designated for use with this product by Emerson Electric Co could result In personal injury or property damage 2 Securely connect the fan motor white wire to the supply white neutral wire using wire connector supplied Figure 16 Securely connect the fan motor black wire and blue wire to the supply black hot wire using wire connector supplied Figure 16 After connections have been made turn leads upward and carefully push feads into the outlet box with the white and green leads on one side of the outlet box and the black lead on the other side of the outlet box 4 WARNING Check to see that ali connections are tight including ground and that no bare wire Is visible at the wire connectors except for the ground wire Do not GROUND hid WIRE LISTED WIR BLACK FAN WIR WHITE SUPPLY NEUTRAL GROUND FROM yo N HANGER BRAG KET 4 WATE on GREEN WIRE BLACK SUPPLY GROUND FROM HOT ANGER BALL NOTE CEILING COVER OMITTED FOR CLARITY Figure 16 LOCKWASHERS 2 THREADED STUD 2 KNURLED KNOB 2 Figure 17 5 Secure the ceiling cover in place by sliding lockwashers over the threaded studs and installing the two knurled knobs supptied F
Download Pdf Manuals
Related Search