Kenroy Home 21521ORB Installation Guide
Contents
1. LB NOT INCLUDED INTO SOCKET 9 LOOSEN ADJUSTMENT KNOB AND ADJUST POLE TO DESIRED HEIGHT TIGHTEN ADJUSTMENT KNOB TO SECURE IN PLACE 10 PLUG THE POWER CORD INTO AN OUTLET AND TURN ON AT SWITCH BULB REPLACEMENT 1 BEFORE REPLACING THE BULB BE SURE THAT THE SHADE AND BULB ARE COOL AND LAMP IS UNPLUGGED 2 UNSCREW EXISTING BULB FROM SOCKET AND REPLACE WITH A NEW BULB PLUG POWER SUPPLY CORD BACK INTO OUTLET TROUBLE SHOOTING 1 IF YOUR LAMP DOES NOT LIGHT CHECK PLUG AT THE OUTLET MAKE SURE THE PLUG IS FULLY AND PROPERLY INSERTED INTO THE POWER OUTLET 2 IF LAMP STILL DOES NOT LIGHT UNPLUG FROM OUTLET CHECK THE BULB FOR A BROKEN FILAMENT REPLACE BULB IF NECESSARY PLUG IN LAMP AND TURN IT ON 3 IF THE LAMP STILL DOES NOT LIGHT PLEASE CONTACT YOUR DISTRIBUTOR OR PLACE OF PURCHASE IMPORTANT SAFETY INSTRUCTIONS THIS PORTABLE LAMP HAS A POLARIZED PLUG ONE BLADE IS WIDER THAN THE OTHER AS A FEATURE TO REDUCE THE RISK OF ELECTRIC SHOCK THIS PLUG WILL FIT IN A POLARIZED OUTLET ONLY ONE WAY IF THE PLUG DOES NOT FIT FULLY IN THE OUTLET REVERSE THE PLUG IF IT STILL DOES NOT FIT CONTACT A QUALIFIED ELECTRICIAN NEVER USE WITH AN EXTENSION CORD UNLESS PLUG CAN BE FULLY INSERTED DO NOT ALTER THE PLUG 215210RB INSTRUCTIONS2. MODEL 215210RB PACKING DIAGRAM LEG 9 0 I LJ DNA HARP amp RUBBER WASHER STYROFOAM 12 KGS CA TITLE 2 EI INIAL RUBBER WASHER SHADE 21521SHORB REPLACEMENT PART HARP LWHARP 9 CH REPLACEMENT HOLDER ADJUSTMENT ONNECTOR 3 PGS a PPER LEG 3 PCS IDDLE LEG 3 PCS POWER LOWER LEG 3 PCS AVAILABLE PARTS ARE 21521SHORB SHADE LWHARP 9 CH HARP ly STED Intertek 4007242 05 2013 ASSEMBLY INSTRUCTIONS READ AND SAVE THESE INSTRUCTIONS READ INSTRUCTIONS ALL THE WAY THROUGH PRIOR TO ASSEMBLY THIS LAMP SHOULD TAKE APPROXIMATELY 15 MINUTES TO ASSEMBLE MAKE SURE ALL PARTS ARE FIRMLY TIGHTENED UNPACK THE LAMP YOU SHOULD HAVE RECEIVED THE FOLLOWING PARTS IN THE PACKAGE FINIAL RUBBER WASHER SHADE HARP SOCKET ASSEMBLY LOWER POLE AND 9 LEGS TO PROTECT THE FINISH PLACE ALL PARTS ON A SOFT SURFACE ASSEMBLE THE LAMP 1 CAREFULLY ORGANIZE AND PLACE ALL PARTS ON A SMOOTH FLAT SURFACE LINE UP ALL OF THE PARTS ACCORDING TO THE ASSEMBLY DIAGRAM 2 SCREW 3 UPPER LEGS TO CONNECTORS SCREW 3 MIDDLE LEGS TO THE UPPER LEGS SCREW 3 LOWER LEGS TO THE MIDDLE LEGS 4 5 SCREW LOWER POLE TO BOTTOM OF UPPER POLE 6 SQUEEZE LEGS OF THE HARP TOGETHER AND INSERT THE TWO ENDS BETWEEN THE PRONGS OF THE HARP HOLDER 7 PLACE SHADE ONTO HARP THEN SECURE WITH RUBBER WASHER AND FINIAL 8 INSTALL A 150 WATT MAXIMUM MEDIUM BASE TYPE A 3 WAY BU
Download Pdf Manuals
Related Search