Sea Gull Lighting 49031BLE-71 Installation Guide
Contents
1. Installation And Safety Instructions HC 764 Sea Gull Lighting Line art shown may not exactly match the fixture enclosed However the installation instructions do apply to this fixture Fill in Item Number on Carton and File This Sheet For Future Reference ITEM 051409 IMPORTANT SAFETY INSTRUCTIONS CLEANING e Be sure the electricity to the system you are working on is To clean wipe fixture with a soft cloth Clean glass with a mild soap turned off either the fuse removed or the circuit breaker set Do not use abrasive materials such as scouring pads or powders at off steel wool or abrasive paper e Use of other manufacturers components will void warranty listing and create a potential safety hazard RDERING PART e You don t need special tools to install this fixture 2 G 2 e Be sure to follow the steps in the order given Keep this sheet for future reference and in case you need to order replacement parts Parts for this fixture can be ordered from place of Readiinstructions carefully purchase Be sure to use exact wording from illustration when e Proper wiring is essential for the safe operation of this fixture e Save these instructions O x jo oO J Q go o 3 v BEFORE YOU BEGIN Carefully remove the fixture from the carton and check that all parts are included as shown in figure 1 Be careful not to misplace any of the screws or parts which are needed to install this fixture INSTALLATION IMPORTANT D2. O NOT ATTACH FIXTURE DIRECTLY TO OUTLET BOX STEP 1 Insert fixture mounting screws B into threaded holes of universal mounting plate A Run screws all the way down to the heads STEP 2 Place universal mounting plate A against outlet box not supplied and screw in place using 8 32 outlet box screws not supplied Be sure the mounting screws B are perfectly vertical so fixture hangs straight OUTLET BOX 8 32 MOUNTING UNIVERSAL gt CANOPY F CAP NUTS G OUTLET SCREWS B MOUNTING BOX TE A SCREWS GROUND WIRE ORANGE cE SUPPORT RING D WIRE GREEN DIFFUSER CONNECTORS GROUNDING lt RETAINING RING B SCREW E FIGURE 1 NOT INCLUDED INSTALLATION continued HC 764 STEP 3 A Use an orange listed wire connector to connect the 18AWG fixture hot wire black wire or round and smooth tracer to the supply hot wire B Use an orange listed wire connector to connect the 18AWG fixture common wire white wire or square and rigid to the supply common wire C Gently try to remove the wires from the connector If you can remove the wires carefully re do the wiring connection GROUNDING INSTRUCTIONS The green grounding screw E is to be inserted into the hole with two raised dimples provided on the universal mounting plate A Wrap the ground wire from the outlet box bare metal or green insulated wire around the green grounding screw E on the universal mounting plate A and tighten the green g
3. rounding screw to secure NEVER CONNECT GROUND WIRE TO BLACK OR WHITE POWER SUPPLY WIRES MARK MEANS LAMP CONTAINS MERCURY FOLLOW DISPOSAL LAWS SEE WWW LAMPRECYCLE ORG FINAL ASSEMBLY Make sure no bare wires can be seen outside wire connectors After wires are connected tuck them carefully inside the outlet box Position canopy F over mounting screws B and secure in place with cap nuts G STEP 2 Install diffuser A and support ring D if necessary over socket and secure with retaining ring B STEP 3 Install self ballasted lamp C by gently twisting into socket CLEANING To clean wipe fixture body with a soft cloth Clean glass with a mild soap Do not use abrasive materials such as scouring pads or powders steel wool or abrasive paper ORDERING PARTS Keep this sheet for future reference and in case you need to order replacement parts Parts for this fixture can be ordered from place of purchase Be sure to use exact wording from illustration when ordering parts ONE PIECE LAMP BALLAST COMBINATION ONE PIECE LAMP BALLAST COMBINATION C gt S SOCKET FIGURE 2
Download Pdf Manuals
Related Search