Sea Gull Lighting 94571-71 Installation Guide
Contents
1. CONTACTS K CAP i CONDUCTOR L FIGURE 3 CONDUCTOR L2. INSTALLATION AND SAFETY INSTRUCTIONS GROUNDING AND MOUNTING BAR LOCK UP FOR OPTIONAL OUTLET MONO POINT CANOPY RAIL RAIL BOX STRAIN ADAPTER R pe ANOPY SCREW P COLLAR J a 3 SPLICE aOR IMENT SCREWS lt STEM M STRAIN RELIEF H HEX NUT amp LOCK WASHER D SOCKET Q Se LAMP ENCLOSURE 8 COLLAR 0 gt as FIGURE 1 NOT INCLUDED FIGURE 2 NOT INCLUDED IMPORTANT SAFETY INSTRUCTIONS NOTE This pendant can be hung either from a Transitions Series e Be sure the electricity to the system you are working on is turned rail not supplied or from the supplied canopy Follow the off either the fuse removed or the circuit breaker set at off instructions for the appropriate mounting method e For use with the 120V Transitions track series by Sea Gull Lighting e Caution To reduce the risk of burn during relamping remove from the track before relamping e If you are unclear as to how to proceed contact a qualified electrician e Minimum distance from the front of the lamp to combustible surfaces is 8 e Make sure all connections are tight e Dimming halogen lamps greatly reduces lamp life e To reduce the risk of a burn during relamping remove from the track before relamping e Turn off and allow to cool before replacing lamp e Lamp gets HOT quickly Contact switch only when turning on e Do not touch hot lens guard or enclosure e Keep lamp away from materials that may bu
3. ding the two halves together Install lamp and lamp enclosure B to socket 2 6 1 2 adapter R Slide collar O canopy G mounting bar F nipple A hex nut and lock washer D over wire to the top of the splice compartment I in that order Install strain relief H to wire Tighten set screw with a flat head screwdriver Secure mounting bar F to outlet box with outlet box screws not supplied Make electrical connections using wire nuts or other UL listed device Be sure that no wires are left exposed a House Black to Fixture Black b House White to Fixture White Wrap fixture ground wire and house ground wire around the green grounding screw located on the mounting bar F Secure by tightening the green grounding screw Carefully tuck wires into outlet box Raise canopy G against ceiling and secure by threading collar O to threaded nipple A ATTACH PENDANT TO RAIL Fig 3 Unthread cap E from rail adapter R Making sure contacts K will align with conductors L on rail set the bottom of the the rail adapter R to the bottom of the rail and roll rail adapter R up onto the rail Install fixture to rail by closing rail adapter R over rail Replace cap E over top of rail adapter R and thread cap E back onto rail adapter R Tighten strain relief screw P located just below rail adapter R INCORRECT CONTACTS K CORRECT
4. rn e Do not touch the lamp at any time Use a soft cloth Oil from skin may damage lamp e Do not operate the luminaire fitting with a missing or damaged shield e Save these instructions AMBIANCE LIGHTING SYSTEMS LR 120 062308 www SeaGullLighting com ASSEMBLING PENDANT SHORTENING PENDANT LR 120 FOR MONO POINT INSTALLATION Fig 2 1 Remove rail adapter R by cutting wire just below rail 1 Determine length of pendant and shorten cable from the splice compartment I Be sure to add 5 for electrical connections when installing as a mono point Unthread splice compartment I Carefully remove wire connections located in the splice compartment I Unthread bottom half of splice compartment I and remove from stem M Install optional shade not supplied by following instructions supplied with shade Set top of splice compartment I and strain relief collar at desired location NOTE Strain relief collar is threaded and should be threaded up and down cable Be sure 1 4 of cable jacket is protruding out of strain relief collar Secure in place by tightening the two set screws Make connections between socket leads and pendant cable using wire nuts inside the splice compartment a Black to Black b White to White c Ground to Ground Make sure no wires are left exposed and carefully tuck wire nuts into bottom half of splice compartment I Close splice compartment I by threa
Download Pdf Manuals
Related Search