Casablanca K1CA-45 Instructions / Assembly
Contents
1. READ AND SAVE THESE INSTRUCTIONS C Comma INSTRUCTIONS FOR MOUNTING THESE CENTER STEM LIGHT FIXTURE K1K K2K K4C WARNING To reduce the possibility of electrical shock be sure that the power is turned off at its source fuse or circuit breaker All electrical components must be installed in accordance with national and local electrical codes To reduce the risk of fire and electrical shock this light fixture should be used only with UL ETL amp CUL Certified Casablanca ceiling fans IMPORTANT Before discarding any packing material locate the following items Fixture Light Bulb s Dimensions w glass Weight K4C 4 60w A15 med base 9 h x 23 w 2 Ibs K1K 1 100w A19 med base 7 h x 9 w 3 Ibs K2K 1 100w A19 med base 6 h x 6 w 3 Ibs 1 Remove the cover from fan by removing two brass 8 32 screws and save these screws for re attaching cover Remove plastic wire nuts from switch housing wires and strip 1 2 insulation from SWITCH both wires black or blue and white Remove the HOUSING center plug from the cover See FIG 1 COVER NOTE If installing this light fixture on a 3 CENTER PLUG Speed pull chain model fan a separate pull 8 32 SCREW chain switch included with the fan must be installed Refer to the following installation instructions otherwise skip to step 4 2 Remove the plastic plug from the fan switch housing Install the light on off switch by inserting WHITE WIRE the c2. hain through hole from the inside Pass the RNURL NUT switch threads into the hole and screw the knurl nut onto the switch Hand tighten firmly See FIG 2 PLASTIG PLUG 3 Attach the blue wire from the fan to one of the BLUE WIRE blue wires on the switch by twisting the bare ends WIRE NUT of the wires together Secure the splice by thread PULL CHAIN ing on one of the wire nuts provided Test the SWITCH secureness of the splice by pulling on the wire nut FIG 2 9943520 REV D KGJUNO3 8A000 4 Guide the two wires from the light fixture through the center plug hole in cover and then thread the light fixture into the center hole Hand tighten firmly See FIG 3 5 While holding light fixture up to the fan attach the wires from the fan switch housing and the wires from the light fixture together black to black or blue to black and white to white by twisting the bare ends of the wires together Then secure the splices by threading on the wire nuts provided Test the secureness of each splice by pulling on the wire nut 6 Re attach the cover and light fixture to the fan switch housing using the two brass 8 32 screws insuring guide pins are properly located into fan switch housing Caution Make sure no wires are pinched between cover and switch housing Tighten the screws to secure light fixture 7 Install glass not included by loosening the thumbscrews on each shadeholder align glass inside shadeholder as far as it
3. will go and tighten thumbscrews equally around the glass Make sure the glass is snug and locked down tight so that the glass will not rattle when the fan is in operation 8 Install the appropriate light bulbs Do not exceed the maximum wattage indicated on the light fixture 9 Connect the fob pull chain to the light pull chain WHITE WIRE BLACK OR BLUE WIRE WIRE NUT BLACK WIRE GUIDE PIN 8 32 SCREW THUMB SCREW LIGHT FIXTURE EXAMPLE
Download Pdf Manuals
Related Search