Aspects WRV213WHPLT Installation Guide
Contents
1. fixture is free from defects in materials and workmanship when installed and used under normal operating conditions for a period of 2 years from date of purchase This warranty covers all component parts and extends only to replacement of defective fixture or components it does not cover failure due to improper installation misuse mishandling or damage incurred in transit 1 of 1 8060668 RO American Fluorescent Y E design efficiency technology LISTED2. HD Supply Vanity Fixture Fluorescent Wall Fixture Model 324296 WRV213 120VAC 60Hz Safety Precautions This fixture is designed for use in a 110 120VAC 60Hz fused circuit Read all safety precautions and installation instructions carefully Do not use on a dimming circuit before installing or servicing this fixture Failure to comply with these instructions could result in potentially fatal electric shock and or To reduce the risk of electrical shock and to assure proper operation this fixture must be adequately grounded To accomplish proper property damage l l _ o l grounding there must be a separate ground wire green contact It 1S recommended that a qualified electrician perform all wiring This between this fixture and the ground connection of your main power fixture must be wired in accordance with all national and local supply panel electrical codes a ee ee l l This fixture is intended to be used for general indoor lighting in dry Do not handle any energized fixture or attempt to energize any fixture locations with wet hands or while standing on a wet or damp surface or in water ASSEMBLY INSTRUCTIONS 1 Preparing for installation A Disconnect electrical power at fuse or circuit breaker box before installing or servicing any part of this fixture B Carefully remove the fixture from the carton 2 Wiring all wiring must take place inside junction box not included Caution Make sure power is off at fu
3. se or circuit breaker box Check power wires for damage or scrapes If power supply wires are within three inches of the ballast power supply use wire suitable for at least 90C 194F Note Most dwellings built before 1985 have supply wire rated to 60C Consult a qualified electrician before installing A Pull the supply wires and the ground wire out from the outlet box not supplied B Position mounting plate 1 over the outlet box by aligning the mounting holes Install the mounting plate 1 on the junction box by securing it with two 2 screws supplied C Make all wire connections to appropriate wire Secure with wire nuts included D Connect the green wire from the fixture to the power source green wire E The black wire from the fixture is connected to the black wire from power source F The white wire from the fixture is connected to the white neutral wire from power source G Tuck all connections neatly into junction box 5 Mounting A Position backpanel 4 over mounting plate 1 and secure it with by tightening two screws 3 supplied on the top and one screw on the bottom 6 Lamp Insert lamps 6 into lamp holder 5 and press upwards until lamp snaps in place 7 Lens Thread stem 7 onto the backplate nipple Place lens 8 over the stem 7 and secure it with the finial 9 8 Restore power at fuse or circuit breaker box Limited Factory Warranty American Fluorescent Corporation warrants this
Download Pdf Manuals
Related Search