Design House 510297 Installation Guide
Contents
1. obtain the services of a qualified electrician CANOPY a KEYHOLE T T SLOT Remove the fixture and the mounting package from the box and make sure that no parts are missing by referencing the illustration SOCKET BULB lt NE ASSEMBLY AND INSTALLATION 1 Before installing preset the NIPPLE length NIPPLE a Thread the HEX NUT onto the NIPPLE and screw the NIPPLE into the COUPLING on the CANOPY a minimum of four turns b Place the center holes of the GLASS SHADE over the NIPPLE and adjust the NIPPLE so that it protrudes out of the CAP 1 4 Remove the GLASS SHADE amp CAP and secure the NIPPLE in place by tightening the HEX NUT 2 Pull the SUPPLY WIRES and the SUPPLY GROUND WIRE out from the JUNCTION BOX and attach the MOUNTING STRAP to the JUNCTION BOX using the slotted holes BES on the MOUNTING STRAP and the MOUNTING SCREWS provided CAP 3 Thread the FIXTURE SCREWS two full turns into the appropriate threaded holes in the 510297 504399 MOUNTING STRAP Check the MOUNTING STRAP against the fixture KEY HOLE FINA J SLOTS to ensure proper fit 4 Make the wiring connection Attach the FIXTURE GROUND WIRE to the SUPPLY IF IN DOUBT ABOUT ELECTRICAL INSTALLATION GROUND WIRE Attach both to the MOUNTING STRAP with the GREEN GROUND CONSULT A LICENSED ELECTRICIAN SCREW Connect the BLACK SUPPLY WIRE to the BLACK FIXTURE WIRE and WHITE SUPPLY WIRE to the WHITE FIXTURE WIRE with WIRE NU2. ASSEMBLY AND INSTALLATION CONT fart 5 Carefully tuck all wiring back into the JUNCTION BOX Lift the CANOPY over the JUNCTION BOX positioning the FIXTURE SCREWS heads through the large openings BRISTOL FLUSH M T CEILING FIXTURE DESIGNHOUSE EAA A KEE Rane iced on of the KEY HOLE SLOTS Rotate the CANOPY until the FIXTURE SCREW heads are seated at the small ends of the KEY HOLE SLOTS secure them with a screwdriver 6 Install the bulbs sold separately Risk of fire Use 2 MAX 60W Type A lamps DO Please read carefully and save these instructions as you may need them at a later date NOT EXCEED THE MAXIMUM WATTAGE 7 Place the center hole of the GLASS SHADE over the NIPPLE and secure it with a HEX C AUTI ON NUT Pass the CAP over NIPPLE and secure it with FINIAL Restore electric power to installation point WARNING Risk of Fire Min 90 C supply conductors Consult a qualified electrician to JUNCTION BOX ensure correct installation SUPPLY WIRE Turn off the main power at the circuit breaker before installing the fixture in order to WIRE NUT prevent possible shock FIXTURE WIRE JUNCTION BOX SCREW GENERAL MOUNTING STRAP C2 e Fe FIXTURE SCREW Il electrical i i ith local ional Electrical So EROUN All electrical connections must be in accordance with local and National Electrical Code GREEN GROUND SCREW N E C standards If you are unfamiliar with proper electrical wiring connections
3. TS Customer Service 1 800 558 8700
Download Pdf Manuals
Related Search