Aspects CSS2072ET Installation Guide
Contents
1. diffuser Wiring All wiring must take place inside junction box Caution Make sure power is off at fuse or circuit breaker box Check power wires for damage or scrapes If power supply wires are within three inches of ballast use wire suitable for at least 90C 194F Note Most dwellings built before 1985 have supply wire rated to 60C Consult a qualified electrician before installing A This unit will not operate properly unless connected to a grounded electrical circuit Electrical shock over heating low or no light output and shortened lamp life can result if proper grounding is not done Securely attach green or green and yellow wire to ground supply wire B Using wire connectors provided connect white supply wire to white ballast lead Connect black hot supply wire to black ballast lead Do not mix wires Pull on each wire lead to make sure connections are secure Make certain no bare wires are exposed outside of wire connectors Mounting A Mount housing 4 to junction box not provided with the two 8 32 x 7 8 screws 7 provided through keyhole slots 8 Lamps A Circline Install small lamp 2 around three inner clips 5 and connect the wire harness connector from the ballast to the lamp that matches the lamp wattage Install large lamp 3 around three outer clips 6 and connect the remaining wire harness connector from the ballast to the lamp B Compact Install lamps 11 by inserting la2. CSS Series Low Profile Soft Edge Fixture Models 2013 2022 2026 2032 2039 2054 2072 Safety Precautions Read all safety precautions and installation instructions carefully Make sure that the power source conforms to the requirements of the before installing or servicing this fixture Failure to comply with fixture See labels on fixture housing these instructions could result in potentially fatal electric shock and or property damage To reduce the risk of electrical shock and to assure proper operation this fixture must be adequately grounded To accomplish proper It is recommended that all wiring be performed by a qualified grounding there must be a separate ground wire green or bare metal electrician This fixture must be wired in accordance with all national contact metal conduit between this fixture and the ground and local electrical codes connection of your main power supply panel The green ground screw location is clearly marked on the fixture housing Do not handle any energized fixture or attempt to energize any fixture with wet hands or while standing on a wet or damp surface or This fixture is intended to be used for general indoor lighting in dry in water or damp locations only Assembly Instructions 1 6 Preparing for installation A Disconnect electrical power before installing or servicing any part of this fixture B Remove diffuser unlatch levers 9 on opposite sides and gently remove
3. mp pins into lamp holder and press until lamp snaps in place Diffuser mounting A Install the square plastic diffuser 1 Align the diffuser 1 inside the bends and to lock the diffuser in place you must rotate the latch until it stops Make sure you locked all latches Power to the fixture can now be restored Limited Factory Warranty American Fluorescent Corporation hereby warranty that this fixture is free from defects in materials and workmanship when installed and used under normal operating conditions for a period of 2 years from date of purchase This warranty covers all component parts and extends only to replacement of defective fixture or components it does not cover failure due to improper installation misuse mishandling or damage incurred in transit Page 1 of 1 8060176 rev 2 American Fluorescent 2345 N Ernie Krueger Circle e Waukegan IL 60087 U PH 847 249 5970 FAX 847 249 2618 JL US www americanfluorescent com LISTED
Download Pdf Manuals
Related Search