Sea Gull Lighting 94113-71 Installation Guide
Contents
1. F against outlet box not supplied and secure in place using outlet box screws not supplied Be sure the mounting screws G are perfectly horizontal so fixture hangs straight X STEP 3 A Take note of the color of the wire s on your fixture Identify which group your fixture wire s falls into and connect the wires according to the directions below L GROUP A CONNECT TO BLACK GROUP B CONNECT TO WHITE HOUSE WIRE HOUSE WIRE BLACK WHITE qa a D PARALLEL WIRE ROUND amp SMOOTH PARALLEL WIRE SQUARE amp RIDGED oS NOTE When parallel wire is used the tracer wire is square shaped or ridged and the less tracer wire is round in shape or smooth Seen best when viewed from wire end To separate wires grasp the ends of each wire and pull apart B Take your fixture wire s from group A and place evenly against the black wire from the outlet box Do Not twist wires together before using wire connectors C Fit a wire connector not supplied over the wires and thread the connector clockwise until you feel a firm resistance D Gently try to remove the wires from the connector If you can pull the wires out carefully re do steps B and C as above and check again for a firm connection E Connect the fixture wire from group B to the white wire from the outlet box in the same manner STEP 4 GROUNDING INSTRUCTIONS The green grounding screw H is to be inserted into the hole with two raised2. dimples provided on the universal mounting bar F Wrap the ground wire from the fixture and the ground wire from the outlet box bare metal or green insulated wire around the green grounding screw H on the universal mounting bar F if uninsulated wire is on the universal mounting bar F connect the ground wire from the fixture and the outlet box to it using a small wire connector not supplied NEVER CONNECT GROUND WIRE TO BLACK OR WHITE POWER SUPPLY WIRES FINAL ASSEMBLY Make sure no bare wires can be seen outside wire connectors STEP 1 After wires are connected tuck them carefully inside the outlet box Position canopy A over mounting screws G and secure in place with cap nuts B STEP 2 Install lamp and glass enclosure STEP 3 Place glass D over canopy A and thread retaining screws E through glass holes and on to mounting arms C to secure CLEANING To clean wipe fixture with a soft cloth Clean glass with a mild soap Do not use abrasive materials such as scouring pads or powders steel wool or abrasive paper ORDERING PARTS Keep this sheet for future reference and in case you need to order replacement parts Parts for this fixture can be ordered from place of purchase Be sure to use exact wording from illustration when ordering parts
3. INSTALLATION AND SAFETY INSTRUCTIONS e You don t need special tools to install this fixture Be sure Carefully remove the fixture from the carton and check that all parts to follow the steps in the order given Read instructions are included as shown in Figures 1 amp 2 Be careful not to misplace carefully any of the screws or parts which are needed to install this fixture e Be sure the electricity to the system you are working on is turned off either the fuse removed or the circuit breaker set at off e If you are unclear as to how to proceed contact a qualified electrician e Use of other manufacturers components will void warranty listing and create a potential safety hazard e Proper wiring is essential for the safe operation of this fixture e Save these instructions UNIVERSAL GROUND MOUNTING WIRE BARD S WIRE CONNECTOR ARMS C RETAINING SCREWS E GLASS D MOUNTING CAP CANOPY A SCREWS G NUTS B FIGURE 1 NOT SUPPLIED GROUNDING amp UNIVERSAL MOUNTING BAR LOCK UP GREEN QUTLET BOX GROUNDING SCREWS SCREW H GROUND AMBIANCE LIGHTING SYSTEMS WIRE CONNECTOR L R 1 0 9 m al 011408 BAR tae FIGURE 2 P NOT SUPPLIED www SeaGullLighting com INSTALLATION LR 109 IMPORTANT DO NOT ATTACH FIXTURE DIRECTLY TO OUTLET STEP 1 Insert mounting screws G in threaded holes of universal mounting bar F Run screws all the way down to the heads STEP 2 Place universal mounting bar
Download Pdf Manuals
Related Search