Minka Lavery 4933-284 Instructions / Assembly
Contents
1. coy hae Ree WRES A YHTE CE Ao RIBBED PaRCLING Re sE WwTAES aR AGR h l eo PES RIND Intertek association Notice It is important to use proper chain pliers not included to OPEN and CLOSE the chain included with this fixture Do not open them with other tools that may twist or stress the chain links It is important to use proper chain pliers like the ones shown in the diagram2. INSTALLATION INSTRUCTION FOR FIXTURE 4933 WARNING SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER AVERTISSEMENT COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR ASSEMBLING THE FIXTURE FIG 1 1 Shut off the power at the fuse box or circuit breaker If necessary remove the old fixture including the mounting hardware 2 Carefully remove the old fixture from the carton and check that all parts are included as shown in the illustration Thread the fixture loop A tightly onto the nipple B Adjust the fixture arms to the proper position Place the glass shade E over the socket F then secure with the cushion ring D and socket ring C 6 Install the light bulb in accordance with fixture s specifications DO NOT EXCEED THE MAXIMUM WATTAGE RATING NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE ie MOUNTING THE FIXTURE FIG 2 1 Thread the nipple S into the collar loop T until snug 2 Thread the other end of nipple S into cross bar P until snug The side of the cross bar marked with GND must face out 3 Place lock washer Q over the end of nipple S protruding through cross bar P and thread hex nut R onto nipple S until tight 4 Take this crossbar assembly and mount to ceiling outlet box V tightly using outlet box screws W 5 Use proper chain pliers to open one end link of the chain and connect to the fixture loop A Close the link 6 By measuring determine correct n
3. umber of links needed for proper hanging height Using a pair of chain pliers disconnect and discard the remaining chain 7 Lace the fixture wires through the chain X 8 Slip collar ring Y over the chain X then do the same with canopy U 9 Open the other end link of the chain X and connect to the collar loop T Close the link 10 Feed the fixture wires through the collar loop T and nipple S and pull until tight CONNECTING THE WIRES WIRING DIAGRAM 11 At this point connect the electrical wire as shown in the wiring illustration making sure that all wire connectors are secured If your outlet has a ground wire green or bare copper connect the fixtures ground wire to it Otherwise connect the fixture ground wire directly to the crossbar using the Green Screw provided 12 Tuck these wires connectors neatly into the ceiling out let box and raise the collar ring Y and thread onto collar loop T protruding through canopy Your installation is now complete Return power to the junction box and test the fixture american lighting M mea SKT RING 26 NFIRB 2 om RING C __ CUSHION RINGO __GLASS SHADE QEP V Set A A 010 Crossbar Ground Screw Mounting screws 2 W Chain HCH3072 281 Gauge 4 5MM X Y
Download Pdf Manuals
Related Search