Minka Lavery 775-301 Installation Guide
Contents
1. G ARM FIXED COLUMN __ YYTOP COLUMN ARM BALL SCREW KP PLATE CAP E CHECK RING D STEEL TUBE oS T 8 NCV FABRIC SHADE A H U CANDLE SLEEVE E T SOCKET C TOP CENTER COLUNN B HEX COUPLING Y P BALL SCREW HANGING THE FIXTURE Fig 3 1 Shut off the power at the circuit breaker and remove old fixture from the ceiling including the old cross bar Thread the nipple C into loop F until snug Thread other endjof nipple C with loop attached into crossbar D until snug Place lock washer B over end of nipple protruding through crossbar and tread hex nut A onto nipple until tight i Take this crossbar assembly and mount to ceiling junction box with junction box screw E Tighten screws securely with screwdriver This side of crossbar marked with GND must face out Use a pair of pliers to open one end link of the chain and connect to the fixture loop J Close the link By measuring determine correct number of links needed for proper hanging height Using pliers Disconnect and discard temaining chain Lace the fixture wires through the chain Slip loop collar H over the chain then do the same with canopy G 10 Open the other end link of the chain and connect to the ceiling loop F Close the link 11 Feed the fixture wires through the loop F and nipple C and pull until taut m AUN oo no CONNECTING THE2. WIRE See fig 2 4 Take the black wire from the ceiling junction box and the smooth wire legs from the fixture and twist bare ends together Twist wire connector onto end of wire until snug 2 Repeat same process with white junction box wire and ribbed wire legs of fixture wire NOTE Twist wire together in the same direction you twist the wire connector onto wire 3 If your junction box has a grounding wire Green or bare copper Attach this wire and the bare copper wire from the fixture together as step 1 If junction box has no ground wire Attach the bare copper fixture wire to the green ground screw on the cross bar 4 Tuck these wires connectors neatly into the ceiling out let box and raise the loop H and thread onto ceiling Loop protruding through canopy Your installation is now complete Return power to the junction box and test the fixture mme EDO me e E gt WRES WRES WIRES aaro WETER GREEN OR SMOOTH RIBBED Sane HOUSE Corer WIRES House GROUND POUSE BLACK WRES WIRES Fig2 KO ware GREEN OR BARE NEUTRAL COPPER GROND american lighting association Listed
3. AS 1 2 3 INSTALLATION INSTRUCTIONS FOR 775 301 ASSEMBLY THE FIXTURE SEMBLY THE FIXTURE Fig 1 Carefully unpack your new fixture and lay out all the parts on a clear area Take care not to lose any small parts necessary for installation Thread the Center stem A into the hex coupling B Thread until snug Place top center column C Steel tube D Check ring E Plate cap F Arm fixed column G top plate cap H metal leave I and Spacer J onto the Center stem A in turns See Fig 1 Secured the top column section by tread the knurled nut K from the op of the center stem A Thread the Loop L onto the top of the center stem A Thread until snug Attach the top arm Y onto the center top column assembly by through the square pin N into the bottom hole of the arm Y Thread the ball screw M through the hole on the top of the arm and connect the arm to center column by thread the ball screw till tight The top column assembly was completed Spread the 5 arms O to evenly position Attach the arm on to the lower center column by using the ball screw P Thread until snug Place the Candie sleeve U onto the socket T Install the correct wattage and type of bulb onto the socket Clip the Fabric shade V onto the bulb Hang the Crystal drops W to the front edge of the metal leave of each arm Fig 1 L LOOP K KNURLED NUT J SPACER A TOP CENTER STEM CL METAL LEAVE CH PLATE CAP
Download Pdf Manuals
Related Search