Minka Lavery 2912-281-L Instructions / Assembly
Contents
1. ALLATION Fig 1 6 Align the fixture E over mounting plate A and secure with screws D Your installation is now complete Return power to the outlet box and test the fixture CAUTION ATTENTION When handling the fixture do not apply pressure to the LEDs Hold the fixture by the base or fixture body E only Replacing LED module Fig 3 The LED module can be replaced by a qualified electrician without cutting the wire and without damaging the decorative element to which the fixture is attached See installation steps for more details Fig 3 Warning Turn off power at the fuse box or circuit breaker before replacing the LED module a To remove the fixture from the wall loosen screws D and remove the wire connectors Then place the fixture on a clear flat surface Loosen screws P and remove frame L and glass shade K Loosen screws J screws M wire fastener N and carefully remove LED module I carefully d Reverse steps a c for installing the new LED module Note The LED module should be provided by a specified supplier Il 783 WIRES Black FIXTURE 7 FIXTURE WIRES White FIXTURE WIRES Green or Bare Copper v Ground HOUSE HOUSE WIRES WIRES Green or White Bare Copper Neutral Ground IMPORTANT Fixture should be installed by a qualified electrician to ensure proper wiring and installation Dimmable with C L CFL amp LED type and Incandescent Ha2. INSTALLATION INSTRUCTIONS FOR 2912 281 L For LED Wall Mount Fixture WARNING SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER AVERTISSEMENT ICOUPER LE COURANT AU NIVEAU DES FUSIBLES OU DO DISJONCTEUR MOUNTING THE FIXTURE Fig 1 1 Shut off power at the fuse box or circuit breaker box If necessary remove the existing fixture and its mounting hardware from the wall 2 Carefully remove the new fixture from the carton and check that all parts are included as shown in the illustration 3 Position mounting plate A on the wall and mark the location of the two drywall anchors G Pre drill the holes for the drywall anchors G then insert the drywall anchors G into the wall 4 Attach the mounting plate A to the outlet box using outlet box screws B Size 8 32 1 2 L and wood screws F The side of the mounting plate marked GND must face out CONNECTION THE WIRES Fig 2 5 Connect the electrical wires as shown in Fig 2 making sure that all wire connectors are secured If your outlet has a ground wire green or bare copper connect the fixture s ground wire to it Otherwise connect the fixture s ground wire directly to the mounting plate using the green screw provided After the wires JUNCTION Box 7 4 2 Set A 021 200121 Mounting plate Green screw Wood screw 2 Plastic drywall anchors 2 Mounting screw 2 Fig 2 are connected tuck them neatly into the outlet box FINISHING THE INST
3. logen type dimmers D Intertek KJ american fig hting s association
Download Pdf Manuals
Related Search