Minka Lavery 4203-290 Installation Guide
Contents
1. then attach the finial base X 9 Hang the adorning M to the loop on the arms K NGING THE FIXTURE Fig 1 10 Thread the nipple C into the loop F until snug 11 Thread the other end of the nipple C with the loop attached into the crossbar D until snug 12 Place lock washer B over end of nipple protruding through crossbar and thread hex nut A onto nipple until tight 13 Take this crossbar assembly and mount fo ceiling junction box with junction box screws E Size 8 32 1 L Tighten screws securely with screwdriver 14 Using proper chain pliers to open one end link of the chain provided and connect to the fixture loop J then close the link 15 By measuring determine correct number of links needed for proper hanging height Using proper chain pliers disconnect and discard remaining chain 16 Lace the fixture wires through the chain 17 Slip loop collar H and canopy G over the chain 18 Open the other end link of the chain and hang the fixture on the loop at the ceiling Close the link 19 Feed the fixture wires through the loop F and nipple C and pull until tight CONNECTING THE WIRES Fig 3 20 Connect the electrical wire as shown in figure 3 making sure that all wire connectors are secured If your outlet has a ground wire green or bare copper connect the fixtures ground wire to it If the junction box has no ground wire attach the bare copper fixture wire to the green ground scr2. 18 Gently raise the glass shade V to bottom of the fixture body S aligning INSTALLATION INSTRUCTIONS FOR 4203 290 WARNING SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER AVERTISSEMENT COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR ASSEMBLING THE FIXTURE Fig 2 1 Shut off the power at the circuit breaker and remove the old fixture from ceiling including the old crossbar 2 Carefully unpack the new fixture and lay all the parts on a clear surface 3 Attach the column N to the fixture body S by turning it clock wise until tight 4 Attach the end of the arm K to the fixture body S with the ball screw R Attach the other end of the arm K to the column N with the ball screw L 5 Place the two glass plates Q smooth side will be on the top over the fixture body S aligning the pipe nipple attach the collar ring P and lock securely with the nut 0 6 Thread the nipple U into the coupling bottom of the fixture body S and then lock it tightly with the hex nut T 7 Install the light bulbs not included in accordance with the fixture s specifications DO NOT EXCEED THE MAXIMUM WATTAGE RATING NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE Junction Box m ling Sot A A 012 Grossbar Ground screw Junction box screws 2 Chaint HCH3072 290 Gauge 4 2nm bis 72 J the hole with the nipple U and lock it securely it with the brass nut W
3. ew Screw 8 32 3 8 L on the crossbar Tuck the wire connections neatly into the ceiling junction box COMPLETING THE INSTALLATION Fig 2 21 Raise the canopy G all the way to the ceiling then raise the loop collar H and thread into ceiling loop protruding through canopy CHAIN HUNG FIXTURE INSTRUCTION Notice It is important to use proper chain pliers not included To OPEN and CLOSE the chain included with this fixture Do not open them with other tools that may twist or stress the chain links It is important to use proper chain pliers like the Your installation is now complete Return power to the junction box and test 5 ones shown in the diagram the fixture gt Fl XTLRE WRES Bare pper HOLBE Ground HOUSE WFES WRS wite Geen or c US rate Neutral Bare Copper ound Intertek american lighting
Download Pdf Manuals
Related Search