Minka Lavery 1188-357 Instructions / Assembly
Contents
1. the link 13 Feed the fixture wires through the loop and pull until taut CONNECTING THE WIRES Fig 4 14 At this point connect the electrical wire as shown in figure 4 1 mal making sure that all wire connectors are secured If your E Junction Box outlet has a ground wire green or bare copper connect the Ceiling fixture s Ground Wire to it Otherwise connect the fixture s Ground Wire directly to the crossbar using the Green Screw Hex Nut provided 15 Tuck these wire connections neatly into the ceiling junction Pon SARNE box and then raise the canopy all the way to the ceiling P ANE IR Raise the lock Colar and thread onto ceiling Loop protruding through canopy SHADE INSTALLATION Fig 2 16 Place Glass Shade M over Socket N and secure tightly with Screw Shel L 47 Screw Nut G to the end of Pipe C then slide Iron Washer F along with Plastic Washer E and Glass Shade D over A tsok Collar Pipe C as shown Fig 2 18 Secure the Giass Shade with Knurl Knob B and Finial A tightly 19 Install the light bulbs in accordance with the fixture s specifications DO NOT EXCEED THE MAXIMUM ig l uc gt WATTAGE RATING wi i Wi ae WIRES Your installation is now complete Return power to the anil i i HEE junction box and test the fixture am ercan i i Grasan PANTA Ground2. INSTALLATION INSTRUCTIONS WARNING SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER ASSEMBLING THE FIXTURE Fig 1 amp 2 1 Carefully remove the fixture from the carton and check that all parts are included as shown in the illustration 2 Shut off power at the circuit breaker and remove old fixture including the crossbar 3 Fix Center Rod H to Stud 1 4 Thread Nipple J into the matched Coupling k to fix side rod instal one side rod at a time HANGING THE FIXTURE Fig 3 5 Thread Nipple into Loop until snug 6 Thread other end of Nipple with Loop attached into crossbar until snug 7 Place Lock Washer over end of Nipple protruding through crossbar and thread Hex Nut onto nipple until tight 8 Take this crossbar assembly and mount to ceiling junction box with junction box screws Tighten screws securely with screwdriver 9 By measuring determine correct number of links needed for proper hanging height 10 Use a pair of pliers to open one end link of the chain attach the chain to the fixture s loop close the link Slip Loop Collar and Canopy over the chain Open the other end link of the chain and lift the fixture to attach to the ceiling loop close the chain link Lace the fixture s wires through the chain links and puil unti taut Feed the fixture wires through the loop and Nipple and pull until taut 12 Open the other end link of the chain and hang the fixture on the loop at the Ceiling Close
Download Pdf Manuals
Related Search