Minka Lavery 668-PL Installation Guide
Contents
1. INSTALLATION INSTRUCTIONS For Model 664 PL 666 PL 668 PL WARNING SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER CAUTION Turn off the main power at the circuit breaker before installing the fixture in order to prevent possible shock GENERAL All electrical connections must be in accordance with local unfamiliar with proper electrical wiring connections obtain the services of a qualified electrician Remove the fixture and the mounting package from the box and make sure that no parts are missing by referencing the illustrations on the installation instruction ASSEMBLY AND INSTALLATION 1 Turn off the power 2 Remove the NUTS 19 from one of the END CAP 18 Then take the End Cap out and pull the Acrylic Lens 21 out from the other end of End Cap 18 3 Pull the SUPPLY WIRES 2 amp 4 and HOUSE COMET a AN GROUND WIRE 3 out from the OUTLET BOX 1 2 WHITE SUPPLY WIRE 13 MOUNTING SCREW 4 Loosen the 2 COPPER NUTS 15 on the FIXTURE 3 HOUSE GROUND WIRE 14 FIXTURE BODY BODY 14 Then take the BACK PANEL 10 out from a a the FIXTURE BODY 14 6 FIXTURE GROUND WIRE 17 SCREW 5 Position the BACK PANEL 10 over the OUTLET 7 BLACK FIXTURE WIRE 18 END CAP BOX 1 Mark the location of the two KEYHOLE e aaa E SLOTS located on the BACK PANEL 10 Be sure to 10 BACK PANEL 21 ACRYLIC LENS mark only the narrow part of the KEYHOLE SLOTS ILSCREW Remove the BACK PANEL 10 from the ceiling Drill the two holes using the appropriately size2. d drill bit Insert the provided Ceiling ANCHORS 9 into the holes 6 Put all the fixture wires through BACK PANEL 10 7 Make the wiring connections connect the WHITE SUPPLY WIRE 2 to the WHITE FIXTURE WIRE 5 connect the BLACK SUPPLY WIRE 4 to the BLACK FIXTURE WIRE 7 connect the HOUSE GROUND Fig 2 WIRE 3 to the FIXTURE GROUND WIRE 6 using FIXTURE FIXTURE FIXTURE WIRE CONNECTOR 8 PROVIDED Carefully tuck Bleck or C White orf Bare all wires back into the OUTLET BOX 1 See Fig 2 rong 8 Locate the BACK PANEL 10 over the OUTLET BOX 1 put the MOUNTING SCREWS 13 through the slots on the back panel Then secure the MOUNTING SCREWS 13 to the OUTLET BOX 1 tightly Secure Neural Grounc the ANCHOR SCREWS 12 to the ANCHORS 9 9 Put the FIXTURE BODY 14 over the BACK PANEL 10 through the two SCREWS 11 and secure it by 2 COPPER NUTS 15 10 Now you are ready to install the LAMP 20 Do not f as american exceed recommended maximum wattage i H htin 11 Insert the ACRYLIC LENS 21 to one end of the End N g 29 Cap Then put the other end cap through the association SCREWS 17 and secured by the NUTS 19 Listed INSTALLATION IS NOW COMPLETED PDF created with pdfFactory Pro trial version www pdffactory com
Download Pdf Manuals
Related Search