Minka Lavery 1815-84 Instructions / Assembly
Contents
1. INSTALLATION INSTRUCTION FOR 1815 WARNING SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER AVERTISSEMENT COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR ASSEMBLING THE FIXTURE Fig 1 1 Carefully remove the fixture from the carton and check that all parts are included as shown in the illustration 2 Thread the loop J onto the nipple K Tighten the loop J 3 Spread the arms S so that the arms S are at equal distance from each other 4 Thread the nut M onto the nipple N then thread the nipple N into the coupling L and tighten with the nut M 5 Slide the tube O cap P and washer Q over the nipple N and secure with the nut R Note To avoid scratching the tube O spread the arms S outward to a suitable position 6 Place the glass U over the socket V and secure in place with retaining ring T HANGING THE FIXTURE Fig 2 7 Shut off the power at the circuit breaker and remove old fixture from ceiling including the mounting bar 8 Thread the nipple E into screw collar G until snug 9 Thread hex nut D onto nipple E place lock washer C over end of nipple E thread nipple E through mounting bar A and continue until tight 10 Take this mounting bar A assembly and mount to ceiling junction box with junction box screws B Tighten screws securely with screwdriver 11 Using a pair of pliers to open the end of chain I and connect it to the loop J and cl2. e Copper Ground l DEPASSER LA PUISSANCE NOMINALE MAXIMALE Your installation is now complete Return power to the junction box and test the fixture f ignting association Notice It is important to use proper chain pliers not included To OPEN and CLOSE the chain included with this fixture Do not open them with other tools that may twist or stress the chain links Itis important to use proper chain pliers like the ones shown in the diagram
3. ose it Fig 2 12 By measuring determine correct number of links needed for proper hanging height Using the pliers disconnect and discard remaining chain 13 Lace the fixture wires through the chain links Slip screw collar ring H over the chain then do the same with the canopy F 14 Open the other end link of the chain I provided and connect it to screw collar G Close the link 15 Feed the fixture wires through the screw collar G and nipple E and pull until taut CONNECTING THE WIRES Fig 3 16 At this point connect the electrical wires as shown in Fig 3 making sure all wire nuts are secured You may have to wrap the connections with electrical tape If your outlet has a ground wire green or bare copper connect fixture s ground wire to it Otherwise connect fixture s Fig 3 ground wire directly to the mounting bar A using the green screw provided FIXTURE t FIXTURE FIXTURE a 17 Tuck these wire connections neatly into the ceiling junction sk WIRES WIRES box and then raise the canopy F all the way to the ceiling iji piade Raise the screw collar ring H and thread onto screw collar aja G protruding through canopy Fig 2 18 Install the light bulbs in accordance with the fixture s specification EES WIRES DO NOT EXCEED THE SPECIFIED WATTAGE NE PAS walle Green or Neutral l l l l HOUSE l l Bar
Download Pdf Manuals
Related Search