Minka Lavery 4965-284 Instructions / Assembly
Contents
1. w IKRES WIR Rk Se RIBBED Sag HESE RIT l oes R QIR w i X2. INSTALLATION INSTRUCTIONS FOR FIXTURE 4965 WARNING SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER AVERTISSEMENT COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR ASSEMBLING THE FIXTURE FIG 2 1 Shut off the power at the fuse box or circuit breaker If necessary remove the old fixture from the ceiling including the mounting hardware 2 Carefully remove the new fixture from carton and check that all parts are included as shown in the illustration Thread the fixture loop A tightly onto the nipple B Adjust the fixture arms to their proper position Place the glass shade E over the socket F then secure with the cushion ring D and socket ring C 6 Install the light bulb in accordance with fixture s specifications DO NOT EXCEED THE MAXIMUM WATTAGE RATING NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE aw MOUNTING THE FIXTURE FIG 1 1 Thread the nipple S into the collar loop T until snug 2 Thread the other end of nipple S into the cross bar P 3 Place lock washer Q over the end of nipple S protruding through the cross bar P and thread hex nut R onto nipple S until tight 4 Take this crossbar assembly and mount to ceiling outlet box V tightly using outlet box screw W The side of the cross bar marked GND must face out Use proper chain pliers to open one end link of the chain and connect to the fixture loop A Close the link By measuring determine the c
3. orrect number of links needed for proper hanging height Using the chain pliers disconnect and discard the remaining chain oa o LOOP A NIPPLE SKT RING 26 mu SOCKET RING C we CUSHION RING D GLASS SHADE E SOCKETP V et A A 010 Crossbar EOE Ground Screw W Mounting screws 2 Carefully lace the fixture wires through the chain X oN Slip collar ring Y over the chain X then do the same with canopy U 9 Open the other end link of the chain X and connect to the collar loop T Close the link 10 Feed the fixture wires through the collar loop T and nipple S and pull until tight CONNECTING THE WIRES 1 At this point connect the electrical wires as shown in the wiring diagram making sure that all wire connectors are secured If PXTURE your outlet box has a ground wire green or bare copper gece connect the fixture s ground wire to it Otherwise connect the SMCOT fixture s ground wire directly to the cross bar using the green screw provided 2 Tuck these wires connectors neatly into the ceiling outlet box and raise the collar ring Y and thread onto collar loop T protruding through canopy Your installation is now complete Return power to the outlet box and test the fixture W american lighting Intertek association Chain HCH3072 84 gee 4 5MM X Y _ FIXTURE LOOP A FIXLLR 5
Download Pdf Manuals
Related Search